0 Members and 23 Guests are viewing this topic.
I am wiring up a 96 4WD Standard trans engine. The Schematic that 4rnrick has shown is for a 2000 motor, and the wiring colors, and locations are different, can someone point me in the right direction for the correct pin-outs?
att: Big Mike , no spark.working on doing a motor swap on 85 pickup and putting the 3rz motor in it. I got the gauge cluster out of a 88 toyota 4runner v6. When i get it all hooked up i am not getting spark. My 3rz motor came out of a 95 tacoma and it has a two coil set up. Will this combination work with the gauges that I have. If not do you have any tips on what to check to find out why I am not getting spark.
looking to update my dd with a 3rz anyone know if I can bolt a 3rz up to a 2wd trans? my daily is a 92 22re with 5speed.
if your motor came out of a 95 tacoma it is not the 2 coil set-up my friend.... my 96 motor has a distributor
What is everyone doing for the oil pressure sensor on this swap? The ORS harness I have says to use a old single wire type oil pressure sensor from a 22re/22r/3vz-fe so pulled one from an old 22r and bolted it in and just hooked up a jumper wire from the sensor to the connector (before I have to change the connector) and fired up the motor and the oil pressure sensor still showed zero. To me it makes sense that it should use this type of sensor for the old style gauges, since that's what it came with, but it's not working.
Started by cruzila « 1 2 ... 32 33 » Rig Gallery
Started by yotaboy79 « 1 2 ... 32 33 » Chit Chat Camp
Started by BLACKDOG « 1 2 ... 11 12 » Chit Chat Camp
Started by Willy Mammoth « 1 2 3 4 5 » Chit Chat Camp
Started by Rocksurfer Chit Chat Camp