0 Members and 3 Guests are viewing this topic.
Oh yeah and we went for a quick wheelin trip last night and I can tell i'm goin to get into some trouble with this thing.
Oh yeah and we went for a quick wheelin trip last night and I can tell I'm goin to get into some trouble with this thing.
It's a lot more fun to to wheel it with a "few" dents than run the "mall crawler". When are you going to fix that camera!
It turned out really nice! What are your plans now? Are there any loose ends yo need to tie up still?
But thanks Gittinit, i'll always be workin on the runner upgrading, replacing and customizing parts that's just what we do on these things
Is this on the bumpstop fully compressed? Remember after the springs settle a bit, you might need to adjust them (I did). With that little bit of cancer, you should just tub the fenders a bit. I'll send you a link to a nice write up.
that's with no bump stop in the rear, i don't think i want it goin anymore than that because it was starting to reverse the shackle end of the spring. What did you use for the rear bump stops, i'm thinkin the old factory front stops
my buddie alans clean 2 seater 85. auto trans, chain t-case, 4.56, 22re, all-poo front springs and alcan rears with some beefy homemade 1/2"x 3 1/2" shackles and no back seats first one I've seen. It's a little goat of a runner. But will soon be upgraded.
Started by SQUIRREL MONSTER Toyota Pickup/4Runner Tech 1979-95
Started by runner88 Engine
Started by slice4653 Project Research and Build-Ups
Started by golana « 1 2 3 » Project Research and Build-Ups
Started by toyotaporvida Transfer Case/Drive Line