0 Members and 30 Guests are viewing this topic.
I had an issue with my rear springs not being exactly the same length. I ended up moving one of the shackle hangers more forward than the other one to get the shackles at the same angle. I wouldn't make any changes to them until you know they are broken in (couple trail runs and some time on the street). You then can make changes to them if need be.
My exhaust is over the d-shaft and I need to move it to where yours is routed. Mine rubs the shaft sometimes, just not enough room. Can you snap a pic of the exhaust next to the duals, mine also is way to close to the cases. But with 2 cats and a Borla turbo muffler mine is super quiet at idle and has a good tone all the way through the revs.
i love your truck, wish i had the garage time and money and patience
I took the truck for a short little cruise yesterday with a friend of mine. We wound up over at the longmont shop and in the parking lot is this pretty deep drain. I thought id flex it out and im sorry i did. It didnt hit me in time that the truck was set up to have an inch longer shackles so when i flexed it out the rear tire rubbed the bed and pulled it down in the seam and smashed it right in front of the bed bob. Kind of a sad day but i will fix it. Im wondering if i should put the longer shackles on the front and get another set for the rear to level it...my fear is what it will do with my caster and if it will get Death wobble.
IronClad: If I wanted to hold hands and be nice I'd become a hippie.
That 3RZ swap is nice... so is the dash; I don't think I would do that though. Me and wiring don't always get along too well. The same goes for clean paint/body, my junk is going to hit something eventually so I wouldn't want to F up some nice work. Where are you in CO?>>Dan
We got the house in Firestone and close on the 9th so im trying to get as much as i can done before then...I also need to find a new job cause the Parts thing didnt work out and the place i was working for is going under.
Nice man, get some pictures of that bumper up! I want to see the rear bumper when you get done too, I want to make a nice swing out carrier for the runner but I need ideas. Hows it runnin?
Congrats on owning a home! Get that pen warmed up for the closing, you'll sign your name several hundred times Sorry to hear about the parts gig not working out. It seemed like you were moving quite a few parts & vehicles.
Started by CruzrDave Parts For Sale
Started by toymech Project Research and Build-Ups
Started by 88wildrunner Parts Wanted
Started by punkrock crawler Parts For Sale
Started by H8PVMNT General 4WD Discussion