The Official MCR6 Who Broke What thread

[*FFC*]

You got it.. who broke what?

I lost both my front shocks and got a few more beauty marks

[Tallchevy]

I was surprised that I didn't break anything........................ Wait, yes I did, I broke wind after the chile beans we had for dinner 

[fordh8r]

I broke a sweat running up Cadillac trying to   of Tallchevy and his rig   up...



And I broke wind   when we three wheeled it coming up Cadillac...That's when I got out and started    


Other than that no other damage...

[iNfErNaL]

MY HEART!!!!!...I ended up with a broken heart after that weekend 

[Tallchevy]

MY HEART!!!!!...I ended up with a broken heart after that weekend 

Looks like it got grilled too 

[iNfErNaL]

   

[*FFC*]

MY HEART!!!!!...I ended up with a broken heart after that weekend 

[MiniSimp]

1. Alternator.

[Blingn]

i had a electrical fire at the top of cad hill, bent my tie rod end so bad i could barley turn left, lost my master cylinder cap and bail found the cap put it on with zip ties.  lost the ignition wiring and justin's dad and i rewired it on big sluice with alot of rigs behind us.  And when i was pulling FFC up the hard parts of cad hill herd a bad snap in my right shaft and lost the oba

[unclejpl4x4]

[Duffil]

my wallet.  I chunked a sidewall, dented a MC Slider and got my bodywork rearranged. I bent my crossmember a little also.

[*FFC*]

my wallet.  I chunked a sidewall, dented a MC Slider and got my bodywork rearranged. I bent my crossmember a little also.

I think that goes without sayin!

[Lady Di]

Nothing that was know of,so far, although Mark said three of the tires are not holding air so well.

[*FFC*]

Nothing that was know of,so far, although Mark said three of the tires are not holding air so well.

Oh yeah I forgot My drivers front tire had a few rocks in the bead... Marlin and Mike jumped in and fixed it for the time being, but my tire was up to almost 30 lbs when we left Cadillac, and now it's completely flat

[snowshoebrue]

i chipped some paint off my fender, but thats it.  i had a good trip

[*** YELLER ***]

  I drove 2 1/2 hours and after a 3 hour delay  and everything was great....  Until I needed the brakes the most..... on the trail, the master Cyl decided to take a huge dump on me and I had none  well I could pump them but they would not hold and well there were none in a 50 mile radious so....

my wallet. 

Check next to the steaks we need to BBQ still 

[yotaboy79]

bent up alot of tubing and broke my twinstick shifter and cut a highpressure steering line

[4.3 headache]

drivers side shock mount & now the driver door wont shut (little sluice box!) 

[kiyul4130]

sheared off all my steering studs on the passenger side knuckle and the trunion bearing was toast. my camber is totally screwed up to on that side now. worse than before.



EDIT: oh ya and my housing is bent. the knuckle ball on the passenger side.

[Rockcrawlintoy]

i broke my timing chain at buck island, lost a bead gettin towed, crunched a fender and driver side bed pretty good

Drew

[welder2000]

We need picks of all the carnage.

[kiyul4130]

We need picks of all the carnage.

just 2 pics of the trail fix.

[Shamb]

bent a heim joint.. almost broke it in half...

Cracked all the tubing that holds the upper 3 link in place and ummm... I crushed my driver side door a bit... doesn't open or close anymore.. I used a piece of speaker wire I had laying on the ground to hold it temp..

[locktup]

I left some red paint on Old Sluice from my right side rear quarter panel. It goes back into the paint shop next month. Getting ready for the Hammers. Got some new project I want to do on it  .

Jason

[Ramrod]

front ring and pinion
lost about 3 gallons of fuel tank capacity from denting
fuel gauge
rear upper shock mount cracking off
dented frame
dented sliders more
cracked muffler

[Sluice Box Hero]

in the box Saturday morning i broke:

1. Transfercase housing
2. Passenger Side Front Spring is bent so bad its touching the frame right infront of the shackle
3. Drivers Side Front Spring Center Pin, ended up using the winch to hold the axle in place
4. Passenger Side Inner and Outer Chromo Black Max Dana 44 axle shafts

drove all the way to the springs with all this broken, then proceeded to walk the wall by the spring, then, while turning around for round two on the wall i broke:

5. Sky's pitman arm adapter

the radiator had been leaking some, while loading it on the trailer sunday night at midnight i lost

6. The Radiator

also, while running my tow rig from loon to meeks bay to pink up my toyota i guess i locked up a trailer tire and smoked it.

7. Trailer Tire

all have everything back together by monday though.

Callen

[OOPS]

Front d-shaft at the bottom of Big Sluice, fixed in camp by Marlin,and me and parts from megolfer. Worked fine wheeling out to Loon. Going to use it again this weekend. Had a bit of a problem with the ram assist, installer error, I forgot to tighten the bolts on the clamp that the ram mounts to on the tie-rod.

[kiyul4130]

all have everything back together by monday though.

Callen

lol ok........bet you $200 lol

[CTorri]

Just a blown motor here!! But did get the Hard Luck Award from Marlin!!   What a pain in the butt pulling this dead thing back up up the hill!!  Thanks to some good friends that were willing to help...for 2 days!! Yea had some breakage problems with that too!!  Thanks guys!! Oh and sorry for any of those behind us on the way out!

[megolfer]

Are you the one that blew the motor because you went through the water to fast anf hydrolocked the motor.