Ok, I got the front suspension done besides the shackles because I am waiting on the 3/4 inch spacers to show up (they were back ordered). I have the axle bolted in, but nothing attached to it. I ran into a few problems:
#1: Shocks- Way too short now. I do have some shocks from the rear of my moms tundra that would work if I had taller shock mounts. Unfortunately, I cannot weld, so talller shock mounts are out of the question. I am not sure what I am going to do about this yet. The stock length shocks that are in there will hinder my flex A LOT.
#2: Brake lines- they are now way too short as well. I will need to be ordering up a set from Marlin sometime soon.
#3: I am afraid my driveshaft may end up being too short, but currently I am not too concerned about it.
Good news is it looks like tyhe flipped j-arm steering will work just fine. Anyways, here are a few pics:
Springs done, Marlin bushings:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Suspension%20mods/DSCF1213.jpg)
Installed:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Suspension%20mods/DSCF1214.jpg)
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Suspension%20mods/DSCF1215.jpg)