Left to do before 3/23/07 aka week long Moab trip
Weld steering box mount to frame
Reinstall steering rod from steering wheel to PS box
Install aussies into stock 4.10 3rd members
Fully build the front axle from spindle out
Reassemble 1 more locking hub
Paint whatever didn't get painted
Install 3rd member in rear after aussie install
Hook up brake lines front and rear
Figure out rear E-brake
Install shock hoops and shocks
Measure for front and rear driveshafts
Make square front driveshaft
Order rear driveshaft
Trailer 4Runner to gpn911's house and fully weld all suspension
Install brake master cylinder
Install clutch master cylinder
Install front brakes
Install rear brakes
Bleed brake and clutch system
Bleed powersteering system
Put gear oil in t-cases, tranny, front and rear diff's
Reinstall radiator, grill, air box
Install tach
Install CB
Figure out rear seat and how to lock it down
Paint and install stock roll bar
Beef up stock gas tank skid plate with some angle iron
Blow all the grinding dust off of it
Wash it
Test drive
Possible off-road shake down run