So while I wait on parts and what not I have a possible fun project. Cost, $35 from ebay. The 22re is megasquirted.
![](http://oppiz.net/pics/4runner/04092015/20150409_210220.jpg)
So i decided to bolt this on.
![](http://oppiz.net/pics/4runner/04092015/20150409_215644.jpg)
Bosch 0280140551. A PWM IAC valve out of a VW. This will give my 22re active idle control. So under load it will up the idle, give better cold start high idle, better power steering/AC high idle and when in low low, simply let off the clutch put load on the motor, while idleing and it will bump the idle up to 1500 RPM. Sweet.
Started by drilling a hole into the MS housing.
![](http://oppiz.net/pics/4runner/04092015/20150409_210714.jpg)
Then soldered everything together. This can be done through the factory harness. But my harness doesn't have A/C, so the wires aren't present. So I am adding it as an extra.
![](http://oppiz.net/pics/4runner/04092015/20150409_210742.jpg)
![](http://oppiz.net/pics/4runner/04092015/20150409_213907.jpg)
![](http://oppiz.net/pics/4runner/04092015/20150409_215504.jpg)