ok so I got a bunch more stuff done to the truck last night... trying to have it ready for our new years wheelin party.... I got my rusted fuel hard line replaced and new fuel filters installed... got my rear axle re-assembled and all the brakes plumbed and bled....I also got the clutch plumbed and bled and then we realized that we forgot to install the little retaining clip/spring onto the clutch fork and throwout bearing so the clutch fork wont stay put.... I am gonna keep my fingers crossed that it will work the way it is for this wheelin trip as I dont care to pull the trans out again.... another problem I ran into was my power-steering hard line from my 3.0l is a tiny bit too small to fit on my 2rz pump....so I need to figure out what to do with that now... I will post up some pics of the steering fitting after work today and see if anyone has any ideas....