0 Members and 19 Guests are viewing this topic.
Here are the measurements I used..From the corner of the hood where the hinge is, units are in inches:And here they are installed They turned out like I had hoped I just used some super simple aluminum angle pieces drilled and tapped for some machine screws
hey mike- look what i picked up today- daytona turbo, its larger then both lebarron vents combinedand ROKTOY- the vents come off chrysler lebarron turbo sedans, late 80s, early 90s.if you want vents, i got some sweet ones off a 280zx turbo
Look how clean that turned out! And that is 1/4"-wall DOM, there is no way it is going to bend!!I will break the pitman arm before I bend that DOM beefy Marlink rod!!Hay Mike, any plans on selling these?
So...... wasn't I supposed to update this thread, or something? I forgot
oh believe me, a LOT has happened that hasn't been covered.hahaha man, someone should get BigMike in here to update his thread
...why buy when you can build?
Pitman arm, don't forget your Sector shaft. <--- I shrunk this image down to prevent confusion. This image is not from my truck It is a great suggestion from Slolyfe that the sector shaft could break if one is not careful!I have not broken my sector shaft yet -BigMike 7/24/2012
how the heck did you break the sector shaft???
Started by HFCRAOffroading « 1 2 » Project Research and Build-Ups
Started by 88Rokyoat « 1 2 3 » Project Research and Build-Ups
Started by AaronB « 1 2 ... 7 8 » Project Research and Build-Ups
Started by Rainer « 1 2 ... 6 7 » Project Research and Build-Ups
Started by SKULLYOTA Transfer Case/Drive Line