Man! this thread has really taken off.
![Tongue :P](https://board.marlincrawler.com/Smileys/marlin/tongue.gif)
;D
I got the passenger side changed just like normal (guess I'll chain them down)
I have the drivers side off and there is a small plate that had a bolt in it. I hammered that bolt out and have the 1/2" one but I still am unsure of something.
If I drill out all the metal that the bolt will go through, what do I do about the rubber motor mount that already has a bolt "stud" in it. I wouldn't drill that out would I? that doesn't make sense. As of right now I am going outside to change the drivers one just like the normal passenger one. then I'll chain them down better (I already chained them once but they were not straight)... I guess this'll do it for motor mounts.
THEN it's on to the mild Drivetrain lift and SKY skidplate. I think I'll save pulling the motor for another day b/c I am not sure I can handle it by myself.
![Undecided :-\](https://board.marlincrawler.com/Smileys/marlin/undecided.gif)
hate to admit that but it's true.
![Yes Nod :yesnod:](https://board.marlincrawler.com/Smileys/marlin/yesnod.gif)
I MIGHT retube the front dshaft though- that I can handle
![Yes Nod :yesnod:](https://board.marlincrawler.com/Smileys/marlin/yesnod.gif)
alright- thanks for reading this DIY.. later man.