Marlin Toyota in Petersen's Mag

[JanMarie13]

Did you spot the Marlin Toy in the September issue of Petersen's 4Wheel Off-Road?  It boasts Marlin Cralwer SAS with 4 inch leaves, Marlin dual cases 4.7 and 2.28 low range with a wide variety of Marlin logos all over the truck.

[KYOTA]

yea and it only cost him $5 

[BigMike]

Yup, that's the sweet rig that was raffled away during a 1-day buildup at last years Tierra Del Sol Safari.

See more about it here: http://board.marlincrawler.com/index.php?topic=9171.0

[Lady Di]

Nice!!! How cool is that. MrsPA! you rock finding that

[Volcom]

Did you spot the Marlin Toy in the September issue of Petersen's 4Wheel Off-Road?  It boasts Marlin Cralwer SAS with 4 inch leaves, Marlin dual cases 4.7 and 2.28 low range with a wide variety of Marlin logos all over the truck.

Back from the dead, anybody like the old school "Ironman" paint scheme?  I'm maybe thinking of doing this same thing to my 4Runner.  I would probably leave the top black however. 

Anybody think that it would look good in spraypaint rather than professionally done or vinyl graphics?

[BLACKDOG]

Back from the dead, anybody like the old school "Ironman" paint scheme?  I'm maybe thinking of doing this same thing to my 4Runner.  I would probably leave the top black however. 

Anybody think that it would look good in spraypaint rather than professionally done or vinyl graphics?

yeah, if you tape it off, it'll look fine   check this out

http://board.marlincrawler.com/index.php?topic=7444.120

page 4 reply 158.  I did that with spray paint and masking tape.

[Volcom]

yeah, if you tape it off, it'll look fine   check this out

http://board.marlincrawler.com/index.php?topic=7444.120

page 4 reply 158.  I did that with spray paint and masking tape.

Nice work with the spray paint!     I either want to go the old school route or paint it all orange