--------------------------------------------------------------------------------
Just got done doing a timing chain and headgasket. got the motor all assembled and go to fire it up, nothing. tried a few more things. still wont crank the motor over, but ECU clicks. i replaced the starter and gave that a try. nothing. so i cut the little wire that plugs into the starter so i could jump it to the main lead on the starter, it now cranks over. when it starts up it barely wants to stay running. distributer is on #1 cylinder at TDC. when i had it running i put the timing light on it and timing was alittle advanced. then i go to turn the dizzy to make it 5* advance and she dies. but i could watch the timing mark move on the lower pully and put it at 5*. checked plugs, wires, vacuum lines, swapped out ECUs, tried mine in another truck and it works fine. still cant figure it out.
Ran the codes and it popped up #10, which is ignition switch, ECU, starter signal. how can i check the switch and signal. im going to soder that starter wire that got snipped, it was short to begin with so it needed some length.
I hope i gave enough info, can anyone help me figure this out.