Progress and such.
Hints of front spring setup:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Suspension%20mods/SpringSlider.jpg)
Got truck in garage:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Summer%202011%20Rebuild/NoBedInGarage.jpg)
Gutted interior and found:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Summer%202011%20Rebuild/RustyFloorNoBueno.jpg)
Installed 1" Body Lift and started on duals.
Explosion:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/DUALS/Explosion.jpg)
And together:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/DUALS/AssembledDuals.jpg)
And where I am hoping to keep it positioned for mounting. I am nearly flatbelly, the lowest point on the transfercase is only one inch lower than the frame. Frame is at 23" and t-case is at 22"
![](http://i230.photobucket.com/albums/ee218/KDXSR5/DUALS/NearlyFlatbelly.jpg)
This caused a bit of a problem though:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Summer%202011%20Rebuild/UhOh.jpg)
While I had everything out of the way I welded together this little puppy:
![](http://i230.photobucket.com/albums/ee218/KDXSR5/muffler/FlexyPipe.jpg)
Then I decided to start playing around with bed ideas. This is a mockup I came up with. The real thing will be built with square and rectangle tubing. The whole setup is bolt-on. This design integrates sliders and a roll bar into the bed. The boxes in front of the wheel well cutouts will house the batteries. It will have a tailgate, I just didn't mock it up. The tubing the model is sitting on represents the Toyota frame to give a bit of a visual on how it will come together.
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Flatbed/0809112246.jpg)
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Flatbed/0809112248.jpg)
![](http://i230.photobucket.com/albums/ee218/KDXSR5/Flatbed/0809112250.jpg)
And that is what I have so far. If you or someone you know is looking to buy a Marlin
![Marlin Crawler Turtle Logo :turtle:](https://board.marlincrawler.com/Smileys/marlin/turtle.gif)
rear bumper for a 2nd gen shortbed truck that is powdercoated gray, let me know.