Well I got enough done to get the rig back on the road and test a few things out. It was really nice out yesterday so I drove it to work. I took some pics when I got home. When I had the front end apart to do the front member, I re-drilled the front leaf spring eye bolt holes up about 1.5" higher in the hanger. That resulted in lowering the front of the truck some more which is great. I took it out and found a rock to flex it on and it looks like everything clears just fine up front. I need to trim a bit more out of the front fenders and I will need to tub the firewall just a bit. My dad came over and got started trimming another two inches out of the rear fenders. I will have to build new fenderwells for the rear. I also cut and shortened my fuel tank 5" so it would fit in the rear of the rig, right above the rear axle. I cut a hole in the floor so the tank could push up through a bit, so I will have to box that shut with some sheetmetal. i also had to do alot of work to the front to get the radiator and fan to fit. i had to cut almost all of the innerstructure out and I had to get rid of the stock hood latch, so I am rockin hood pins now! I am really lovin the way it looks without the body lift!