yes i have the complete interior harness also. im not to worried, it should be ok. today as i l;ooked at my motor, i was going off the gasket surface on the oilpan and not the sump. now that i look at it, the oil sump is perfectly level. so my braket fabrication went well. what i had to do was take the driver side motor mount bracket off the block and used the plasma cutter to remove about 1 inch out(shorter). then for the pass side i took the bracket off and drilled out the bottom hole where the little locater pin on the actual mount is to the larger diameter of the bolt that hold the mount to the bracket. then flipped the mount around. this narrowed up the mounts and gave me the proper angle i needed. ill post some pics tomoprrow to give you a better idea.
