Daily Driven Wheelers

[46&2]

Where do you live that you get hassled for that? You got flaps and not super wide.

My tires stick out about a little over half an inch and I have been cited for mud flaps and fender flares twice. At least in the CA vehicle code its a gray area, and they use that to ticket people. I just run mudflaps though, screw fender flares.

[jimbo74]

my daily driver's

Belleville 300 DES ST - Hot Weather Tan Safety Toe Boot

Price: $122.66

My Price: FREE (Gov't Issue )

[brockbuilt85]

my daily driver's

Belleville 300 DES ST - Hot Weather Tan Safety Toe Boot

Price: $122.66

My Price: FREE (Gov't Issue )

so you take your chevralegs to work then?

[Halladay]

my daily driver's

Belleville 300 DES ST - Hot Weather Tan Safety Toe Boot

Price: $122.66

My Price: FREE (Gov't Issue )

Nothing Wrong with them 

[thegoofster21]

i made one of this a while ago http://board.marlincrawler.com/index.php?topic=57601.0

[yjay]

i made one of this a while ago http://board.marlincrawler.com/index.php?topic=57601.0

I digress. I intended this as a thread for people to show their daily driven wheelers and changed the title to reflect that.

[yjay]

My tires stick out about a little over half an inch and I have been cited for mud flaps and fender flares twice. At least in the CA vehicle code its a gray area, and they use that to ticket people. I just run mudflaps though, screw fender flares.

I moved from cali 5 years ago. I drive past the cop shop 2 times each day in my runner and previously in my Jeep with no fenders on the front and never had an issue. It's a shame how stiff the police and gov't are now down there cause it's beautiful but I finally had to bounce.
PS. In Idaho, Washington, Montana, Wyoming, and other free states it is a citizens right to be able to obtain a concealed weapons permit as long as you are not a felon. Try to get one in Ca. as a private citizen. Kinda rambling but I felt I had to leave.

[thegoofster21]

I digress. I intended this as a thread for people to show their daily driven wheelers and changed the title to reflect that.

oh just showin i made something close to the samething

[46&2]

I moved from cali 5 years ago. I drive past the cop shop 2 times each day in my runner and previously in my Jeep with no fenders on the front and never had an issue. It's a shame how stiff the police and gov't are now down there cause it's beautiful but I finally had to bounce.
PS. In Idaho, Washington, Montana, Wyoming, and other free states it is a citizens right to be able to obtain a concealed weapons permit as long as you are not a felon. Try to get one in Ca. as a private citizen. Kinda rambling but I felt I had to leave.

Yup, Diane Finestein is opposed to CCW permits yet she has one herself....

[brockbuilt85]

Nothing Wrong with them 

your right there, i ment no disrespect. thems some bitchin boots

[sricruiser]

Lets get this thread back on track.  Here's my junk.   

1980 hilux, 20r, powersteering conversion, 35" BFG MTR's,  Offenhauser intake, Factory Shower System (rust holes in my roof),  Regeared Thirds.  I drive this truck to work and back everyday, and it still has yet to fail me.   

[axled89]

hey man i like that truck, nice and clean lookin.

[thegoofster21]

hey man i like that truck, nice and clean lookin.

X2 looks like you have been taking care of it

[axled89]

i got a freind that is talking about buy a first gen.   wait till i see him and tell him about that one.    yea he'll go crazy .

[sricruiser]

Thanks axled,  thanks goofster.  I have to be completely honest.  The picture makes it look a lot better than it is for some reason.  I definetely try to take care of it the best I can, but it's got a long way to go.    When I bought it, it already had the lift.  The rear has almost 5 inch blocks, so I'm gonna do the f150 spring swap.  The front looks like they have put the old All Pro Setup.  I'm gonna switch back to the 20r header, and I already have a 22r carb with the LCE plate.  Just need some time to do it.  The Offy needs too much rev to get anything out of it, and i definetely would not recomended it for wheeling. 

[ajordan1975]

when did you get the 35's Neil???

[sricruiser]

About  a month and a half ago.  How'r the duals comin' Andy?

[ajordan1975]

there not just yet...... still need a little more money. hope to order the rest of the parts next paycheck.

[88_Pathy]

This one was when Twisted owned it. 22re, dual ultimate, soft lockers, 5.29s and 35 Toyos, all custom tube work done by him, wrangler fronts and 63in rears.....

[79coyotefrg]

Thanks axled,  thanks goofster.  I have to be completely honest.  The picture makes it look a lot better than it is for some reason.  I definetely try to take care of it the best I can, but it's got a long way to go.    When I bought it, it already had the lift.  The rear has almost 5 inch blocks, so I'm gonna do the f150 spring swap.  The front looks like they have put the old All Pro Setup.  I'm gonna switch back to the 20r header, and I already have a 22r carb with the LCE plate.  Just need some time to do it.  The Offy needs too much rev to get anything out of it, and i definetely would not recomended it for wheeling. 

20R header??  if a "header"  then good call but if your going to put the stock 20R exhaust manifold back on DONT because it will restrict what youre doing by going to the 22R carb

if not a header use the stock 22R exhaust,

[hilux-1983]

Lets get this thread back on track.  Here's my junk.   

1980 hilux, 20r, powersteering conversion, 35" BFG MTR's,  Offenhauser intake, Factory Shower System (rust holes in my roof),  Regeared Thirds.  I drive this truck to work and back everyday, and it still has yet to fail me.   

I like it, I like it! Almost like looking into a mirror.

[sricruiser]

20R header??  if a "header"  then good call but if your going to put the stock 20R exhaust manifold back on DONT because it will restrict what youre doing by going to the 22R carb

if not a header use the stock 22R exhaust,

Thanks for the correction and the input Glen.  I meant to say 20r intake manifold.   So before I put the 22r carb/20r intake, I need to get at least a 22r exhaust manifold on for me to actually gain from the mod? 

I like it, I like it! Almost like looking into a mirror.

Thanks 83,  Our color seems to be popular on this board.  Thanks again for the sweet deal on the power steering stuff

[79coyotefrg]

yea the 20R exhaust manifold is very restrictive,  a 22R manifold will bolt up and flows better

you had a 22R intake on a 20R ?

[sricruiser]

yea the 20R exhaust manifold is very restrictive,  a 22R manifold will bolt up and flows better

you had a 22R intake on a 20R ?

Nope,  I currently have an Offy w/ a motorcraft carb  on the 20r.   This is the setup that came with the truck when I bought it. I have collected a 22r carb, LCE adapter plate, and a 20r intake that I plan to put in.

[jonathan82toy]

She is a daily driven wheeler for sure.   

[84socal]

my dd  37s 5.29s  assies      longs   duals  caged  doved     basic run of the mill yota   and its beaten on





and its carbed
http://www.youtube.com/watch?v=olES5LJq8BQ

[crazykooter]

She is a daily driven wheeler for sure.   

Jon get your ars back in sales so I can call you for parts you jack ars.   My 82 powns your 82 btw !!!!!   

Here is my DD still. Tho I seem to spend more time on it fixing stuff then I do driving it these days.  Shes pretty close to being ready for 4dice.

[Halladay]

Jon get your ars back in sales so I can call you for parts you jack ars.   My 82 powns your 82 btw !!!!!   

Here is my DD still. Tho I seem to spend more time on it fixing stuff then I do driving it these days.  Shes pretty close to being ready for 4dice.

what is in your bed?!

[axled89]

    x2??

[79coyotefrg]

Nope,  I currently have an Offy w/ a motorcraft carb  on the 20r.   This is the setup that came with the truck when I bought it. I have collected a 22r carb, LCE adapter plate, and a 20r intake that I plan to put in.

OH 



when you coming to get that cab roof ??