Topic: 85 Axle overhaul

[Redeyejedi]

i have just gotten into the break down and rebuild of my '85 axle and was wondering if i should replace the knuckle studs, bolts and cone washers.
also, do the 54mm nuts, tag washer and star washer come in the knuckle service kit available on this site?
thanks

[KDXSR5]

the tag washers come with the kit, but not the nuts if I remember correctly. I only replaced stuff that got messed up such as a few of my hub cone washers.

[79coyotefrg]

if you arnt running 37's and hydro assist  and your studs arent damaged i see no need to replace them

then 54mm nuts do NOT  come in the kit  but i believe Marlin does sell them

[Redeyejedi [OP]]

thanks, good lookin out

and what are you guys using to clean up the grease and other nasties caked on the knuckles?

[KDXSR5]

and what are you guys using to clean up the grease and other nasties caked on the knuckles?

My solvent tank and/or a wirewheel depending upon the part. Before I had a tank, I would just use many many many cans of brake clean and a brush.

[lucky7]

Make sure to tighten up those studs or you might end up needing some