0 Members and 12 Guests are viewing this topic.
BigMike,
Hell...should have never got into wheeling with a Daihatsu Rocky!!!
hep, master cylinder was what i was talking bout. huh, i thought the v6 trucks were only an 1" bore. thanks
had to cut the body cross saprot to make the one on the front fit, but I just welded in a pice of 1X1 tube to takes its place. and now it works fine!
Hey mikey, how about some more info on your gas tank? I just got a long bed gen 2 tank from toytaboy and would like to think about putting it in . would a 1" bed lift do it ya think? cut and weld the rear shocks mount too? any advice would be great!
I went with the FROR cross member and skid plate thinking it would be easier to install than Marlin's...don't know but it is in.
I am going to end up with about a 24" rear drive shaft but a looong front drive shaft.
There isn't room to mount the cultch master cylinder so the plan is to run the clutch cable to the passenger fender and fab up a bracket and lever to actuate the master cyinder and run a line to the slave.
Any more progress and pics?
Mmmmmmm, blue booby with chrome mesh bra, mmmmmmm
Started by Mike D Engine
Started by gturismo Chit Chat Camp
Started by BigMike « 1 2 ... 18 19 » Project Research and Build-Ups
Started by BigMike « 1 2 ... 11 12 » Trail Reports, Events, and Gatherings
Started by BigMike « 1 2 3 » Trail Reports, Events, and Gatherings