MCR check list!! The clock it ticking

[Blingn]

Ok what is left to do on your guys/gals rigs? 

I'll update mine after this weekend, cause we are having a fab party.  I was just wondering if I was the only dork that has a crap load of stuff to do on there rig.     the clock is ticking MCR crew!!! 


1.

2.

3.

ect.......

[*FFC*]

IF the Migo makes it:

Bold are supposed to be done tomorrow:

>New rear driveshaft
>Flip rear leafs
>Install Tcase
>Install new brakes
>New starter
>Install Shocks
>Mount/remount rock lights
>Smog
>Register
>Insure
>Inspect/replace pass wheel bearing



Optional:

>Clutch
>

[Tallchevy]

Here's my list

1. Mount fire ext
2. Have to   tow hooks in front
3.   Diff covers
4. Change passenger side motor mount
5. Steering stabilizer
6. Get camping gear ready
7. Get some tools packed & ready
8. Install inclimeter (not really important right now)

The week of the 14th
1. Change engine oil
2. Check trans, t-case & diff oil levels
3. Check steering & grease
4. Check & torque suspension

I'll be ready  

[Tallchevy]

IF the Migo makes it:

>New starter

Hey FFC! If you get it all except for this, I have a hammer you can borrow 

[MiniSimp]

Tune TPS
Pull Transmission & Transfer Cases
Rebuild Transfer Cases
New Seals on Transfer Case
Rebuild FROR Crossmember
Install Transmission & Transfer Case & Crossmember
Install Exhaust
Install LCE Motor Mounts
Install CB
Install DSR Shock
Install Shifters
Install Front Square Driveshaft
Install Rear Square Driveshaft
Fill Transmission and Transfercases with oil
Torque All Nuts And Bolts
Pay Neighbor Kid $5 $10 to Wash it
Buy new TPS Sensor, install it, adjust it, get less pissed at it.
Find why motor won't run properly
Organize tools and spare parts
Take to Carnegie and try to break right before MCR6

[*FFC*]

Hey FFC! If you get it all except for this, I have a hammer you can borrow 

I just may hold ya to it If I kept my tcase out, I could just reach through the floor and hit it, without even havin to get out

[snowshoebrue]

technically all i have to do is put in the new transmission, and get second propane tank

what i want to get done
get new housing machined and installed
buy custom length 30 splines for said housing
buy hub gears, hub studs, new drag link/tie rod, arp knuckles studs, drivers knuckle for new housing
install new ram mounts on new housing
truss,shave, and mount tacoma rear housing
t case ebrake and twin stick
new seats
second winch and battery and then install new gauge panel
flatbelly
mount rear johnny joints
rear traction bar
mount wheel well protection bars
new paint

[CTENG in KS]

It is too big to type...
I have to finish the runner and the Beastmaster to a degree of functionality
plus pack the tools/spares
figure out food and junk.
I will be at this til the last minute fer sure.

[Shamb]

I'm on the same boat as far as functionality goes, my brakes are fug'd up and I gotta get 'em working right. Install a hydro cooler and my fan.

I've got some rear tube to RE-weld and fab some brace supports so I can beat on this mofo come MCR time

Doesn't sound like much but the way my lucks been going lately...    don't ask.

[Duffil]

find a spare and a wheel for it.
fire extinguisher.
save money so I can eat while I'm there.
get carb working better.
smog and register so I'm legal to get there.
get more tools together for the trip.
figure out carpool/wheeling situation.
get spares and fluids together.
Go to KMart.  I hear they have balls on sale, and that I should bring some to wheel the 'Con.

[Lady Di]

find a spare and a wheel for it.
fire extinguisher.
save money so I can eat while I'm there.
get carb working better.
smog and register so I'm legal to get there.
get more tools together for the trip.
figure out carpool/wheeling situation.
get spares and fluids together.
Go to KMart.  I hear they have balls on sale, and that I should bring some to wheel the 'Con.

  it does take some balls! LOL


OMG ALL THE LISTS!!!   

I've got to get food prepped and stocked
Get the junk cleaned out of the LBC and get it cleaned, and inventoried.
Start getting clothes ready.
MAPS! I NEED MAPS!!  :willnilly:

I am sure MrDub's list is a bit more of what you were looking for.

[Cheesemaker]

IF the Migo makes it:

Bold are supposed to be done tomorrow:

>New rear driveshaft
>Flip rear leafs
>Install Tcase
>Install new brakes
>New starter
>Install Shocks
>Mount/remount rock lights
>Smog
>Register
>Insure
>Inspect/replace pass wheel bearing



Optional:

Wheelie Bar!!
>Clutch
>




I edited it for ya!! 

[Cheesemaker]

I'm just jealous, because I won't be able to go this year!  Maybe next year, I'll make some time to drive down and ride shotgun with somebody on the run! 

[*FFC*]

Wheelie Bar!!
>Clutch
>




I edited it for ya!! 

  Funny you should say that, Matt, Justin and Dave were jokin about puttin one on it yesterday

[BLACKDOG]

  Funny you should say that, Matt, Justin and Dave were jokin about puttin one on it yesterday

joking?  what do you think we were planning while you were gone at Lowes?   

[IronClad]

if i decide i want to go.. uh.. build a  whole truck is my list.. lol

[BigMike]

Things I must accomplish:
1) Replace head gasket

Things I would like to accomplish:
1) Finish the rest of my on board air system
2) Dyno tune engine
3) Upgrade Alternator
4) Install more rock lighting

That's about it. Pretty short list for me this time

[*** YELLER ***]

 

1.  Finish brakes 
2. mount winch 
3. weld cracked frame 
4. check all fluids
5. DRIVE IT TO DA ROUND UP AND PRAY

[Tallchevy]

Here's my list

1. Mount fire ext
2. Have to   tow hooks in front Fabing, will be done on Monday
3.   Diff covers Fabing, will be done next week
4. Change passenger side motor mount
5. Steering stabilizer I don't have one so looks like it will have to wait until after MCR6
6. Get camping gear ready
7. Get some tools packed & ready
8. Install inclimeter (not really important right now)

The week of the 14th
1. Change engine oil
2. Check trans, t-case & diff oil levels
3. Check steering & grease
4. Check & torque suspension

I'll be ready  

[Duffil]

I have a procomp one you can have.  slightly blem, but works fine.

[Rockcrawlintoy]

i need to finish my rear bumper for sure and get new shock hoops for the front so i can tie in my bumper to the hoops. Things i would like to do is to get alloy shafts for the front that really about it

Drew

[Tallchevy]

I have a procomp one you can have.  slightly blem, but works fine.

Is it an eye on one side & a stud on the other? I have a stud to stud but no bracket. It's for the stock location.

[Wermz84]

Way too much cause I hurt my freeking back and haven't been able to touch my truck in a month.  Meanwhile the parts keep piling up in my front room.

[rockscrambler]

Passenger front axle seal
Replace front brakes
Inspect rear diff-repair,replace,or adjust source of horable combination of grinding,whineing,and chewing noise
If above is the limited slip install locker
Replace radio
Install front reciever for removable winch
but this is just going thru the motions just in case some miracle occurs and I go. I want to be ready. 

[Tallchevy]

Since I'm driving there & hopefully back   I'm going to build a square tube rear shaft to exchange while I'm there. That way I don't rip up my street d-line 

[Blingn]

1: finish rear of cage
2: hook up the lights
3: hook up the cd player to speakers
4: bolt check
5: fluid check
6: mount new toggle for lights
7: mount rear bumper
8: fix steering wheel
9: seat belt harness for passangers side
10: make the doors
MORE PAINT!!!

[Duffil]

Is it an eye on one side & a stud on the other? I have a stud to stud but no bracket. It's for the stock location.

sorry no its eye to eye

[Rockcrawlintoy]

Since I'm driving there & hopefully back  I'm going to build a square tube rear shaft to exchange while I'm there. That way I don't rip up my street d-line 

ya me too for sure since i have a 398321983 inch wheelbase

[Tallchevy]

sorry no its eye to eye

Thanks anyway  I do have one on my Blazer that I was going to use but it's an eye to eye  I just might make some brackets for the one I have.

[Wermz84]

• Secure Rental Truck
  
• Secure Rental Trailer
  
• Install Marlin Transmission
  
• Install Marlin T-case and Twin Stick
  
• Install aussie locker
  

Hopefully I can get to that.

No Lift before this year.