Author Topic: cuting with propane (Read 1076 times)

89 toy · « **on:** Jun 27, 2005, 10:34:15 PM »

has any body used propane instead of acetalyne in their torch. do you have to use a different tip?i ran out of gas while torching the ifs off and am using it seems to work ok but takes a while to heat up.

trevinotrek · « **Reply #1 on:** Jun 27, 2005, 10:51:11 PM »

you dont have to change anything just be careful it has a tip the looks like an after uner. we use it to cut 1 1/2 - 2 " platejust set it low and work up your setting .

Author Topic: cuting with propane (Read 1076 times)

89 toy

cuting with propane

trevinotrek

Re: cuting with propane

Related Topics


	Author Topic: cuting with propane (Read 1076 times) 0 Members and 1 Guest are viewing this topic. 89 toy Rock Master Turtle Points: -1198 Posts: 383 Member since Dec '03 Crawling with Marlin cuting with propane « on: Jun 27, 2005, 10:34:15 PM » has any body used propane instead of acetalyne in their torch. do you have to use a different tip?i ran out of gas while torching the ifs off and am using it seems to work ok but takes a while to heat up. Logged 89 ext cab sas with diamond +4 1/2" housing 30 spline longs and hub gears, hp elocker, six studs, arp studs in everything, taco rear with elocker. swaped out 22re for 3.4l supercharged, urd 2.0" pulley, urd fuel management, downey headers, flowmaster, cold air intake, marlin clutch that is straining to hold up trevinotrek Rock Master Turtle Points: 279 Posts: 236 Member since Sep '04 Crawling with Marlin Re: cuting with propane « Reply #1 on: Jun 27, 2005, 10:51:11 PM » you dont have to change anything just be careful it has a tip the looks like an after uner. we use it to cut 1 1/2 - 2 " platejust set it low and work up your setting . Logged aint skeerd " watch this" ok so maby it was a littlte to bigto get over .Stop laughing and turn me over