![](http://volcom.rockfrogs.org/front-bumper/001.JPG)
Stock front cross member. 3 mounts on each side, super thin boxed tubing and some lightly tacked captured nuts from the factory 25 years ago.
![](http://volcom.rockfrogs.org/front-bumper/002.JPG)
I added 2 more supports on each side. I cut 45 degree cuts on a piece of 2"x2"x3/16" square tubing. Drilled a 1.2" hole and welded a nut to the back. I then welded them to the factory crossmember.
![](http://volcom.rockfrogs.org/front-bumper/003.JPG)
There was a dent in the frame on this side. Somebody filled the dent in the tubing with Bondo
![](http://volcom.rockfrogs.org/front-bumper/004.JPG)
The 4 extra supports.
![](http://volcom.rockfrogs.org/front-bumper/005.JPG)
1/4" plate that fits in front of the factory crossmember.
![](http://volcom.rockfrogs.org/front-bumper/006.JPG)
Welded in place.
![](http://volcom.rockfrogs.org/front-bumper/007.JPG)
It's not coming off anytime soon.
![](http://volcom.rockfrogs.org/front-bumper/008.JPG)
Addicted Off Road front bumper now bolts to the orginal 6 holes and my extra 4.
![](http://volcom.rockfrogs.org/front-bumper/009.JPG)
Still need to replace that headlight
![](http://volcom.rockfrogs.org/front-bumper/010.JPG)
![](http://volcom.rockfrogs.org/front-bumper/011.JPG)
![](http://volcom.rockfrogs.org/front-bumper/012.JPG)
Nice aproach angle!