« on: Apr 10, 2015, 05:10:14 PM »
@OOPS
Tried to google 'toyota jig bar'. Didn't get to clear of results.
I'm guessing it is a bar close to the 'ID' of the axle housing that goes all the way through the entire housing (assuming it isnt bent).
If housing is bent it hangs or scrapes or closes a gap at som point and that is what tells you.
Is that the basic idea? Or am I completely off?
And i'm guessing you don't think any of my 3 ideas are or should cause a slight pull to the left?
Logged
If I don't ask the stupid question, who will?
85 Runner, 22RE, AEM 'warm intake', TRD Cam, LC Headers, Dual Case, 5.29's, ARB Front Locker, Detroit Rear Locker, 35's, V6 Brakes, ARP Studs, Marlin Arms/Caps/Hy-Steer, Winch, Armor, Can-Back Top....and...
...more Gremlins than Gizmo the Mogwai was responsible for.
