Pages: [1]   Go Down
 
Print
 

Author Topic: throwout bearing???  (Read 3037 times)

0 Members and 4 Guests are viewing this topic.

konarider1993

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
throwout bearing???
« on: Sep 15, 2011, 10:03:40 PM »
Ive had this noise for awhile and its been steady getting worse. It sounds like throwout bearing but it also howls when im pulling up a hill in 4th or anytime really if im not touching the gas right, not only just when I push the clutch in.  :dunno:
Logged

junya92toy

  • Offline The 1.5K Club
  • **
  • Turtle Points: -64
  • Male Posts: 1,500
    • Member since Nov '04
  • Drinking me beer
    • View Profile
Re: throwout bearing???
« Reply #1 on: Sep 16, 2011, 06:00:32 PM »
Its the muffler bearing actually.
Logged
Dr.Maxwe001 – well i have a 15 gal compressor now and if I gett he 60  and then use the 15 as a reserve that wil give me 75 gal  thats close to 80 isnt it ?

brainlessfool

  • It's not my problem if you can't hear the voices too.
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 2730
  • Male Posts: 4,207
    • Member since Jun '02
  • drive fast or the devil may get ya
    • View Profile
    • Buy me a cigar
Re: throwout bearing???
« Reply #2 on: Sep 16, 2011, 11:20:08 PM »
Have you check the output flange? some times the nut comes loose.
Logged
A good day working, that's just sick :reg:

konarider1993 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
Re: throwout bearing???
« Reply #3 on: Sep 16, 2011, 11:53:23 PM »
Quote from: brainlessfool on Sep 16, 2011, 11:20:08 PM
Have you check the output flange? some times the nut comes loose.
no wheres the output flange??
Logged

konarider1993 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
Re: throwout bearing???
« Reply #4 on: Sep 17, 2011, 12:06:46 AM »
Quote from: junya92toy on Sep 16, 2011, 06:00:32 PM
Its the muffler bearing actually.
ill need to borrow a spagnasty from u because i figure ill change the blinker fluid the same time i do the muffler bearing
Logged

Tofudude

  • Offline Rock Master
  • ***
  • Turtle Points: -31
  • Posts: 321
    • Member since Jun '10
    • View Profile
Re: throwout bearing???
« Reply #5 on: Sep 17, 2011, 01:37:33 AM »
throwout bearing...like the one in the bell housing? that one would only sound bad if the clutch is pushed in though.
Logged

junya92toy

  • Offline The 1.5K Club
  • **
  • Turtle Points: -64
  • Male Posts: 1,500
    • Member since Nov '04
  • Drinking me beer
    • View Profile
Re: throwout bearing???
« Reply #6 on: Sep 17, 2011, 08:00:05 AM »
Quote from: Tofudude on Sep 17, 2011, 01:37:33 AM
throwout bearing...like the one in the bell housing? that one would only sound bad if the clutch is pushed in though.

No the one in the rear diff
Logged
Dr.Maxwe001 – well i have a 15 gal compressor now and if I gett he 60  and then use the 15 as a reserve that wil give me 75 gal  thats close to 80 isnt it ?

junya92toy

  • Offline The 1.5K Club
  • **
  • Turtle Points: -64
  • Male Posts: 1,500
    • Member since Nov '04
  • Drinking me beer
    • View Profile
Re: throwout bearing???
« Reply #7 on: Sep 17, 2011, 08:01:37 AM »
A good place to start is to actually inform us of what kind of truck you, what model, engine, trans, and mods, since we are humans and cant read minds.
Logged
Dr.Maxwe001 – well i have a 15 gal compressor now and if I gett he 60  and then use the 15 as a reserve that wil give me 75 gal  thats close to 80 isnt it ?

konarider1993 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
Re: throwout bearing???
« Reply #8 on: Sep 17, 2011, 11:43:28 AM »
It does howl when i push in the clutch, only when im moving, and the faster im going the worse it is. But it also makes pretty much the same noise when im pulling up a hill in 4th at low rpms.

What i drive is an 87' runner with a 22re and a 5spd. trail gear sas, 5" trail gear lift, tg hi steer, spool in rear, trussed yota axles
Logged

junya92toy

  • Offline The 1.5K Club
  • **
  • Turtle Points: -64
  • Male Posts: 1,500
    • Member since Nov '04
  • Drinking me beer
    • View Profile
Re: throwout bearing???
« Reply #9 on: Sep 17, 2011, 12:07:59 PM »
Pull it and check it out, or just replace it, how long as that clutch been in there?
Logged
Dr.Maxwe001 – well i have a 15 gal compressor now and if I gett he 60  and then use the 15 as a reserve that wil give me 75 gal  thats close to 80 isnt it ?

twistedtoy92

  • Offline Silver Turtle Award
  • *
  • Turtle Points: -255
  • Male Posts: 3,781
    • Member since Dec '06
  • NFM Customs
    • View Profile
Re: throwout bearing???
« Reply #10 on: Sep 17, 2011, 03:45:46 PM »
sounds like the main shaft bearing in your transmission. 4th gear is a direct drive so it does not transfer a load through the secondary shaft.
Logged
2005 Audi A4 2.0T Quattro 380 AWHP @ 24psi
1993 Toyota Pickup http://board.marlincrawler.com/index.php?topic=72886.msg866982#msg866982
1992 Toyota Pickup http://board.marlincrawler.com/index.php?topic=49319.msg616251#msg616251
1985 4runner http://board.marlincrawler.com/index.php?topic=60737.msg745263#msg745263

"TRIPLE CASES GETS YOU LAID." -BigMike

"I daily drive this thang everyday." (swapped89)

brainlessfool

  • It's not my problem if you can't hear the voices too.
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 2730
  • Male Posts: 4,207
    • Member since Jun '02
  • drive fast or the devil may get ya
    • View Profile
    • Buy me a cigar
Re: throwout bearing???
« Reply #11 on: Sep 17, 2011, 04:05:40 PM »
Quote from: twistedtoy92 on Sep 17, 2011, 03:45:46 PM
sounds like the main shaft bearing in your transmission. 4th gear is a direct drive so it does not transfer a load through the secondary shaft.


X2 not the clutch  :twocents:
Logged
A good day working, that's just sick :reg:

konarider1993 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
Re: throwout bearing???
« Reply #12 on: Sep 18, 2011, 04:04:17 PM »
Quote from: twistedtoy92 on Sep 17, 2011, 03:45:46 PM
sounds like the main shaft bearing in your transmission. 4th gear is a direct drive so it does not transfer a load through the secondary shaft.

sounds about right
Logged

79coyotefrg

  • Rock Ninja
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 1452
  • Male Posts: 22,633
    • Member since May '02
  • Solid axle Toys Rule ! ! !
    • View Profile
    • HotSprings Superlift ORV park
Re: throwout bearing???
« Reply #13 on: Oct 06, 2011, 06:16:23 PM »
Quote from: konarider1993 on Sep 17, 2011, 11:43:28 AM
It does howl when i push in the clutch, only when im moving, and the faster im going the worse it is. But it also makes pretty much the same noise when im pulling up a hill in 4th at low rpms.

What i drive is an 87' runner with a 22re and a 5spd. trail gear sas, 5" trail gear lift, tg hi steer, spool in rear, trussed yota axles
:eek:


please feel free to read this thread -> http://board.marlincrawler.com/index.php?topic=36377.0
Logged
AR-TTORA founder 22R bored.060,LCE stage II race cam http://pure-gas.org/    32/36weber, :driving: Marlin 1200 NON ceramic clutch, L52SHD+dualcase #2919, cable-locker, Yukon 5.29 gears, 35's, Allpro ebrake, front springs, and high steer, F150rears    RIP Nitro 9-29-07 :(  I sure miss him :down: MarlinCrawlerInc IS NOT affiliated with TrailGear in any way

konarider1993 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
Re: throwout bearing???
« Reply #14 on: Oct 10, 2011, 04:09:12 PM »
Quote from: 79coyotefrg on Oct 06, 2011, 06:16:23 PM
:eek:


please feel free to read this thread -> http://board.marlincrawler.com/index.php?topic=36377.0

I agree stay far away from trail gear i got this truck given to me pretty much for free sad story haha
Logged

twistedtoy92

  • Offline Silver Turtle Award
  • *
  • Turtle Points: -255
  • Male Posts: 3,781
    • Member since Dec '06
  • NFM Customs
    • View Profile
Re: throwout bearing???
« Reply #15 on: Oct 11, 2011, 07:04:56 PM »
Off topic........
Logged
2005 Audi A4 2.0T Quattro 380 AWHP @ 24psi
1993 Toyota Pickup http://board.marlincrawler.com/index.php?topic=72886.msg866982#msg866982
1992 Toyota Pickup http://board.marlincrawler.com/index.php?topic=49319.msg616251#msg616251
1985 4runner http://board.marlincrawler.com/index.php?topic=60737.msg745263#msg745263

"TRIPLE CASES GETS YOU LAID." -BigMike

"I daily drive this thang everyday." (swapped89)

konarider1993 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 101
    • Member since May '11
    • View Profile
Re: throwout bearing???
« Reply #16 on: Oct 11, 2011, 08:29:06 PM »
my buddy said his was doing the same thing when his throwout bearing was bad
Logged
Pages: [1]   Go Up
 
Print
 
 
 
 

Related Topics
45 Replies
11856 Views 		Last post Mar 22, 2005, 10:08:52 PM
by BLACKDOG
2 Replies
1752 Views 		Last post Mar 20, 2005, 08:18:13 AM
by 79coyotefrg
5 Replies
2188 Views 		Last post Mar 15, 2007, 08:15:43 PM
by RABIDYOTA
10 Replies
3919 Views 		Last post Aug 25, 2008, 07:34:06 AM
by 83MT
7 Replies
1962 Views 		Last post Jan 23, 2010, 06:14:07 AM
by 2manytoys