Parts truck in CA 1980 Yota Updated 11/24

[8Snaces]

Ok.. I have a 1980 yota short bed. All that is left is 4spd manual trans and stock tcase. I believe there is a 20r under the hood.

Ok..Prices are negotioable but everything must go.

**Motor 20R = 100 obo  (gone)**
**Stock front axle = 200  (GONE! to TallChevy)**
**Stock axle with welded rear = 200 (GONE! to an old coworker)**
**Stock 4spd trans w/ stock single case = 150  (gone)**
**Stock springs front & rear = 40 per set (LF/RF 1set) (LR/RR 1set) (gone)**
**2nd set of rears=40 (gone)**
**Stock body-passenger door smashed and passenger side of bed bent = make offer (gone)**
**Frame is straight to my knowledge = make offer (gone)**



Other stuff...
**Seats out of my truck = 40 (gone)**
A set of half doors = 40 bux for the pair
Spare rear axle housing = 40   *...1 interested buyer...*

**--1999 Chevy S-10 p/u 2wd auto, 4.3Vortec, Tape/FM(stock), 187,xxx, Ext Cab. $1900 O.B.O!!!--**




PM me or email me at myspace for more info or to arrange "junk yard times".

[Tallchevy]

I'm interested in the front axle.

[buckeye1437]

do you have the  radiator were you at

[AaronB]

location?

[89toy]

You happen to have the rear driveshaft?

[8Snaces]

Yes i have the radiator but it has a pin hole leak in the bottom passenger side. I do have the rear drive shaft. I am located in San Ramon, CA. 94583.

[89toy]

how much would you want for the d-shaft shipped to 79832?

[Tallchevy]

PM sent

[8Snaces]

89toy--no shipping.. i will help get it home if its nearby but im not dismantling and shipping. Sorry.

[8Snaces]

Driveshaft is sold. Being picked up on Sunday. Thanx Rocko.

[pyrosnow911]

pics of the tires to [email protected] thanks

[8Snaces]

Pyro- I will take some pics of the tires and a few of the body/parts. They will b posted (hopefully) sometime this afternoon.

[Tallchevy]

PM sent

[8Snaces]

Got the PM TallChevy. I will let u know this week. I will call u and set it up. Fri is out becuz i work 2 jobs. Most likely saturday will b ok but we will c how the week goes. Thx.

[yotacrwlr]

if you still have that front axle that would be awsome ill give you $300 for it. give me a call 707-803-4101 justin. thanks

[Tallchevy]

Got the PM TallChevy. I will let u know this week. I will call u and set it up. Fri is out becuz i work 2 jobs. Most likely saturday will b ok but we will c how the week goes. Thx.

Saturday, Sunday or during the week in the evenings is good for me to pick up that front axle. Let me know.

Do you still have the front driveshaft?

[8Snaces]

Saturday would be great. Anytime after...9ish or 10. Til.... whenever. I do have the drive shaft sitting in the back of the truck.

[8Snaces]

Just snapped a few pics of the truck. Motor shots, guage cluster, tires, rear axle, front axle, my half doors. They will be posted up tonite. Im headin off to work. Chk back tmw morning for the pics.

[Tallchevy]

PM sent. 9'ish sounds good to me 

[8Snaces]

Pics of most of the parts available. More pics today if i can.

[Mnmstoy]

what are you asking for your ignition system?

Mike
my zip is 78228

[8Snaces]

Not sure how much it will go for but im not shipping anything.

[jimbo74]

what is up with the half doors in the bed? what generation are they?

do you have one of these?



also, what gears are in the rear? if they are 4.10s would you trade them to me for a set of 4.10 open?

my truck is almost running chris!!!! AHHHH!!!!! possibly tomorrow

[Tallchevy]

Thanks for the front axle Chris!

[8Snaces]

Tallchevy- Your welcome. Thanx for showing me how quick and easy it was.

Jimbo- The doors are 1st gen. They stamp on the ring gear says 4.37. They are welded at the moment. I dont have a use for 4.10s ... i run 5.29s and mite bump up later. I will look for that part. Is it vacuum or fuel?

[jimbo74]

Tallchevy- Your welcome. Thanx for showing me how quick and easy it was.

Jimbo- The doors are 1st gen. They stamp on the ring gear says 4.37. They are welded at the moment. I dont have a use for 4.10s ... i run 5.29s and mite bump up later. I will look for that part. Is it vacuum or fuel?

its a vacuum thing over on the passenger side of the engine bay and mine was screwed into the side of the water neck....

[Tallchevy]

PM sent about 4.37

[8Snaces]

UPDATE!!!! SEE TOP SECTION!!! Added somethings that are also on the chopblock. Check it out and pass it along.

[THE ROCK]

 :usa:interested in half doors-still available? Im in vallejo

[8Snaces]

THE ROCK-They are still available. Come and get them on sunday if you want. I will be home. PM if ur still interested and ill give you my address. Thanx.