Topic: Rear axle, inner seal install

[Huhwhye]

I just destroyed my new inner seal trying to install it on my '00 4runner.

I put the seal in the freezer overnight and tried to tap them in with a big socket.  Didn't want to go it so I tapped harder.  Then in went in cadiwompus and I noticed I dented the metal part of the seal pretty good.

I'd like to get it right the next time.  Going to the dealer tommorow to get a new seal maybe a few extras just in case. Any suggestions on getting this thing in their?

Thanks

[Tallchevy]

Just make sure it's stays straight & tap lightly.

[Huhwhye [OP]]

I probably hit it too hard.  I started soft but it didn't want to go.  with a little more force  

Looking at the manual, of course they suggest a SST.  At this point I almost am willing to buy the SST just to get it done.

[COToy91]

i lined it up straight then put a 2x4 over it and tapped it with a hammer went in easy and straight

[DTB]

I dont usually recommend using hardened sockets for this reason.......

I usually use wood....either a broom handle, hammer handle or something similar with a flat surface

[OOPS]

Harbor Freight has a seal driver set for cheap. Under $10.00 if I remember right.

[Huhwhye [OP]]

I found this one HF seal installer

cost is 32.99.  If it works I'm willing to buy it.

[OOPS]

This is the one I was talking about. Mine works fine.

18 PC. SEAL DRIVER KIT   
Place oil and lube seals quickly and easily without damage. 16 adapters for any size seal up to 3-3/8'' diameter. Light sturdy handle is built for daily use.
Includes 16 adapters for 1-1/4'' to 3-3/8'' outside diameter, handle, and 3-1/2'' x 1/8'' washer.

ITEM 35555-4VGA

$7.99

[EarlKann]

X whatever.  Use wood or spend a few bucks on a driver kit.