0 Members and 1 Guest are viewing this topic.
I think they just use 1/2in plates and try to pass that off as 5/8th. Can you believe it? 1/4 inch tolerance on CNC?!!!
excuse me but you asked for 5/8ths and got 1/2 where did you figure thats 1/4 difference ?? 1/2 is the same as 4/8ths, which if you passed second grade that would make 1/8th difference in thickness
Those are not stained. That is marking from the factory where the material is made. No fault there.
Just use some rubbing alcohol, that should take the markings off.
Started by snorklehead Chit Chat Camp
Started by Mike D New Member Check-In!
Started by Lord Orange « 1 2 » Stolen Rigs and Theft!!
Started by CTENG in KS General 4WD Discussion
Started by werty Chit Chat Camp