Marlin to the rescue

Started by KYOTA, September 02, 2006, 02:48:10 PM

0 Members and 1 Guest are viewing this topic.

KYOTA

just recieved my Sept/Oct 4wd Toy owner mag and see its Marlin to the rescue helping an FJ Cruiser owner that broke a control arm and mangled some sheet metal get rolling again at the TTORA 'Con event.  :beer: to Marlin

79coyotefrg

AR-TTORA founder 22R bored.060,LCE stage II race cam http://pure-gas.org/    32/36weber, :driving: Marlin 1200 NON ceramic clutch, L52SHD+dualcase #2919, cable-locker, Yukon 5.29 gears, 35's, Allpro ebrake, front springs, and high steer, F150rears    RIP Nitro 9-29-07 :(  I sure miss him :down: MarlinCrawlerInc IS NOT affiliated with TrailGear in any way

tacomamike

Quote from: KYOTA on September 02, 2006, 02:48:10 PM
just recieved my Sept/Oct 4wd Toy owner mag and see its Marlin to the rescue helping an FJ Cruiser owner that broke a control arm and mangled some sheet metal get rolling again at the TTORA 'Con event.  :beer: to Marlin


I was there!  Marlin worked his ass off to help the unprepared FJ driver get out of the trail.  The yellow FJ now belongs to bentup.com and will be turned into a wheeling machine!

Huge props to Marlin for going out of his way to help someone who probably shouldn't have been there to start with.

Later,
....Mike
http://www.toy4x4.net/

Rocksurfer

That's just Marlin, and should be how we all are when it comes to helping someone on the trail that got into it over their heads, or needs some other type of help. It isn't like he broke while travelling down Interstate 5 or something. I've always been that way, in fact once I was going to High Desert Roundup and there was a motorhome on the side of the road with a Jeep in tow. Even though they had any type of service required around I stopped to see what happened. Turns out they blew a radiator hose, since I lived in the area I gave him a ride to Autozone to get a new hose, helped him install it and made sure he got back on the road. Just think how you'd feel if you were in trouble offroad and someone came by and just kept going, that would just suck.

I've known Marlin to open his shop to help a stranded fellow wheeler. :thumbsup:
The Ghost-Rider/Ghost Runner

No matter how far you fall, the ground will always catch you

Willy Mammoth

yup, I am the same way, I have been knowned to take people to my house and work on their junk for free just because I could help.

And that person you passed on the trail you didn't help may pass you and not help when you are in trouble. What comes around goes around.

That's why I set myself up with as much stuff as I can cause I am more prepared to help myself and others if needed.

Way to go Marlin. :thumbs:
:usa: American by birth, redneck by choice. 

Making Of http://board.marlincrawler.com/index.php?topic=6472.0  

Sightings Of  http://board.marlincrawler.com/index.php?topic=10805.0

Hottrod81


boggerunner

its called karma, and it has worked really good for me, i carry lots of spare junk i know i'll never break, but everyone else always needs some spare junk they forgot

*FFC*

He sure saved my :moon: this weekend.... along with tons of other rigs.  :bowdown: Marlin!!
"Yesterday is history, tomorrow is a mystery, today is a gift - that's why they call it the present." - RW Emerson -

Blue Devil Toyota

Our group saw him fixing a few diferent rigs. He even helped with the rolled Bronco o the way out.

Thanks Marlin

Bernie
"Woody"
Four Dice 4 Wheel Drive Club
San Jose CA

TacoRunner

Thank you Marlin for being their when we needed you.
www.4WHEELUNDERGROUND.com
[email protected]
AKA The GODFATHER The 3RZ Original

Performance Tuned shocks for Leaf Sprung Vehicles   http://www.4wheelunderground.com/Tuning.html

4XFlyin

I had a friend tell me today how Marlin helped a budy of ours at MCR that stipped out his third member. I realized that this was the 3rd person I knew that had been bailed out by Marlin over the years. I will always give my referals and support to Marlin.

Toys and Marlin for ever!!!
82 1st Gen with 4.3L vortec and 4l60e. Linked front and rear

My build up. Getting linked
http://board.marlincrawler.com/index.php?topic=50700.msg711361#msg711361

KYOTA

Did Marlin even get to wheel this weekend with all the work he did?  :hahaha:

*FFC*

Quote from: KYOTA on September 12, 2006, 05:29:10 PM
Did Marlin even get to wheel this weekend with all the work he did?  :hahaha:

Hardly... with his alternator goin out ever ten seconds :sad2: :headshake:
"Yesterday is history, tomorrow is a mystery, today is a gift - that's why they call it the present." - RW Emerson -

Marlin

Hope to receive my big frame ford alternator from Premeir tomorrow.
With my new 3RZFE motor, I hope there is more room to install the bigger alt.
I am soo tired of burning up the GM 10DN/12SI units.

I want everone to know that I had a great time at the MCR-5, in spite of helping a number of people.
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....

Blue Devil Toyota

Not only did Marlin help nearly everyone out, he turned around and donated the proceeds from the weekend to FOTR. WOW what a guy. Marlin you are the man.
"Woody"
Four Dice 4 Wheel Drive Club
San Jose CA

Hyena

We past him when he was helping Nub replace a rear output shaft.  they basically rebuilt the whole transfercase right there along the trail.  nice to have air tools.  Marlin was right there under the truck and everything.  it is nice to have good people out there on the trail that are willing to help out total strangers.