0 Members and 1 Guest are viewing this topic.
I have a friend running completly stock rear springs up front on an 83.
Built my spring pack for my "Rears up front"They should be nice compared to my currently reversed springs.Opened up the clamps. Need bushings.Specs:1st leaf: 85 1st leaf2nd leaf: 85 2nd leaf3rd leaf: 85 3rd leaf4th leaf: 85 1st leaf cut down5th leaf: 85 3rd leaf cut down6th leaf: AAL
i got 87 rears
i have access to 67 bronco rears, good adda leafs?
i agree, i just have no patience...
all i have is the cases, dual ultimate with twin sticks, all hand made by marlin
3 leaf rears in the front will be inverted with negative lift.You need to add more leaves, 6-7 is about right.
ditch the overload, its a rock anchoradd 3 leaves you cut to fit below the 3 'rear' main leafs(no overload). the springs you add can be 6-7mm leafs near 2.5'' wide. keep all the spring clamps and even weld something across the top to keep them together...
:bull crap: Count how many people are using an overload leaf for their front springs (rears up front) in this thread: http://www.pirate4x4.com/forum/showthread.php?t=265669
Make sure you don't just toss the load leaf and not support the main pack, if you don't they'll bend and possible break. Always have a load leaf to a pack that requires one.
Started by TigerToy Project Research and Build-Ups
Started by BCB General 4WD Discussion
Started by yotapride Engine
Started by H8PVMNT Engine
Started by yotacrawler1 Engine