Pages: [1]   Go Down
 
Print
 

Author Topic: Noise valves.  (Read 3887 times)

0 Members and 3 Guests are viewing this topic.

79coyotefrg

  • Rock Ninja
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 1452
  • Male Posts: 22,633
    • Member since May '02
  • Solid axle Toys Rule ! ! !
    • View Profile
    • HotSprings Superlift ORV park
Re: Noise valves.
« on: Dec 02, 2009, 09:44:46 AM »
Quote from: Confederate13 on Dec 02, 2009, 07:48:09 AM
would to tight cause power loss or to loose?
too tight can burn the lobes off the cam shaft, break the end of the adjusting screw, make the valve contact the piston which will bend or break the valve causing engine failure


DONT TIGHTEN TOO TIGHT :slap:
Logged
AR-TTORA founder 22R bored.060,LCE stage II race cam http://pure-gas.org/    32/36weber, :driving: Marlin 1200 NON ceramic clutch, L52SHD+dualcase #2919, cable-locker, Yukon 5.29 gears, 35's, Allpro ebrake, front springs, and high steer, F150rears    RIP Nitro 9-29-07 :(  I sure miss him :down: MarlinCrawlerInc IS NOT affiliated with TrailGear in any way
Pages: [1]   Go Up
 
Print
 
 
 
 

Related Topics
34 Replies
5929 Views 		Last post Mar 13, 2005, 06:51:42 PM
by 79coyotefrg
1 Replies
2151 Views 		Last post Dec 17, 2007, 06:38:56 PM
by swervin curvin
1 Replies
795 Views 		Last post Dec 23, 2007, 08:01:30 PM
by fordh8r
8 Replies
1890 Views 		Last post Nov 27, 2009, 12:42:51 AM
by Plekto
10 Replies
2940 Views 		Last post Dec 20, 2013, 02:39:58 PM
by Cletis Crawdad