well, i'm deciding that i'm gonna junk that roll bar. not the welder's fault, but i took a look at it and it's just so incredibly crooked(the 2 supports aren't on the same angle and 1 is longer than the other
), not to mention i found EVEN MORE bondo. looks like i'll have to find another project to use the little box again
the only problem i've noticed so far is that the roller, while being steel, isn't knurled in the channel that the wire goes in so it tends to slip if the gun lead is too twisted up or at a bunch of wierd bends. however for the most part it's working great and laying down a nice weld
