0 Members and 7 Guests are viewing this topic.
Those are some huge welds!
some people will say that 1. 1/4 sch 40 is better (And cheaper) than HREW for slider/bumpers/ non structural partsthen there are the "pipe is for poop" people, then the "use nothing but chrome molly" people... the fact of the matter is. some pipe is strong enough to be used for a cage, its heavier by linear foot than HREW, dom hrew, and obviously CroMo. When compared to strength vs size.dont know if that made since. sorta did to meanyway, i was always in the pipe for non life saving use only crowd. Until i witnessed a fully pipe built roll cage in a toyota do an ass over flip and come out un-scathed.... not saying i would use it, but if built right pipe does seem to serve its purpose.
No, they're all the same. You can generally get sch40 pipe from a pluming supply house cheaper
Do not post misinformation. Pipe is not all created equal, The pipe used in plumping is far different than the pipe used in structural building ( yes i said structural, you think buildings are made from hrew/dom?).Towers are not built from hrew/rew/dom but from PIPE. There is even seamless pipe that is made the same way as "dom".
Some contracts even call out USA only made steel, no china junk
The stuff you want is uncoated sch. 40 pipe. It is the same as hrew but made to pipe dimensions for diameter and wall thickness. I believe the grade is A53f or something close. I work at a steel fab shop and we use tons of this, not for cages, but catwalks and handrails and columns for steel buildings. It bends the same as tubing but needs pipe size dies. We have a real nice hydraulic bender at work and if I decide to do a cage I'll probably use this pipe. Hope that helps someone.
Started by MidgetMike Chit Chat Camp
Started by dirtyskivies Project Research and Build-Ups
Started by MiniSimp Project Research and Build-Ups
Started by surfindave General 4WD Discussion
Started by Cheesemaker Engine