Topic: question about a tanny swap

[yota-tota]

Ok i have 91 yotee with the g58 5speed and i want to swap a w56 or somthing similar with a gear t-case so i was wondering if i can just keep my bellhousing and just bolt up the w56? The tranny i'm looking at is just that the tranny so i dont want to have to lurk around for a bellhousing if i don't have to.

[79coyotefrg]

i'm not sure but  i dont think that (G58) bellhousing will fit to a w56

contact Dirtoyboy for a w56 bellhousing http://board.marlincrawler.com/index.php?topic=39620.480

[Marlin]

All 1984 thur 95 G52, 54 and 58's use the same bell as the 85 thur 95 W56 A,B,C,D and E's.

They also use the same bellhousing bolts, fork, fork pivot, fork boot, release bearing, and slave cylinder.

Marlin

[jimbo74]

All 1984 thur 95 G52, 54 and 58's use the same bell as the 85 thur 95 W56 A,B,C,D and E's.

They also use the same bellhousing bolts, fork, fork pivot, fork boot, release bearing, and slave cylinder.

Marlin

AND NO ONE KNOWS THIS BETTER!!!!!!!!

i say sticky! this is very good info

[79coyotefrg]

All 1984 thur 95 G52, 54 and 58's use the same bell as the 85 thur 95 W56 A,B,C,D and E's.

They also use the same bellhousing bolts, fork, fork pivot, fork boot, release bearing, and slave cylinder.

Marlin

   i knew the G58 was a oddball 

Thanks Marlin,  I'm glad  you have some time to get on and spread  the  immense wealth of knowledge

[yota-tota [OP]]

All 1984 thur 95 G52, 54 and 58's use the same bell as the 85 thur 95 W56 A,B,C,D and E's.

They also use the same bellhousing bolts, fork, fork pivot, fork boot, release bearing, and slave cylinder.

Marlin

Awesome!! So i can swap my bellhousing to the w56!! Yayyyyy!!

[Toymin8r]

All 1984 thur 95 G52, 54 and 58's use the same bell as the 85 thur 95 W56 A,B,C,D and E's.

They also use the same bellhousing bolts, fork, fork pivot, fork boot, release bearing, and slave cylinder.

Marlin

THE GREAT OZ HAS SPOKEN!!!