Author Topic: 1987 Toyota Parts, SR5, frame, IFS frontend, LOOK!! (Read 4198 times)

Glen1978 · « **on:** Jun 02, 2007, 02:31:01 PM »

I have got some parts from an 87 SR5 reg cab for sale. Only interior is the dash pieces. I have all the IFS stuff for sale minus the hubs and calipers.

Steering columm w/key and tilt
SR5 guage cluster (no bezel and speedo needle broke 1/4 way up)
dash, has some cracks
misc. trim from dash
everything under dash (blower motor, ducts, heat/ac controls)
front skid plate

Allot of other stuff, if it bolted to the firewall or frame I probably got it. The rest is gone.

I will have the frame up for sale here really soon when I get the motor pulled and the rear end out. All the IFS stuff is for sale and appears to be in great shape. All stuff is best offer and will ship on your dime. LIke before not gonna sit here and list a price on every little thing. All located in NE Texas.

thanks for looking

skyscraper · « **Reply #1 on:** Jun 02, 2007, 07:13:03 PM »

what would be the price for the tilt column shipped to 93422? thanks

BoG-ToY · « **Reply #2 on:** Jun 02, 2007, 09:34:09 PM »

did it have air conditioning?

Glen1978 · « **Reply #3 on:** Jun 03, 2007, 08:42:56 AM »

Something in my head is telling me the column is not tilt. I will have to check it today and also on the A/C. What were you needing from the A/C?

AaronB · « **Reply #4 on:** Jun 03, 2007, 09:11:00 AM »

I could use the mounting bracket/tensioner for the a/c!

Glen1978 · « **Reply #5 on:** Jun 03, 2007, 09:15:36 AM »

Dont have an A/C bracket. Sorry

BoG-ToY · « **Reply #6 on:** Jun 03, 2007, 09:56:50 AM »

I NEED A COMPLETE A/C setup, a good compressor, that hasnt been sitting open, or used as on board air, lines, dryer, condenser, basically everything except the in dash box, but need the switch and junk

BoG-ToY · « **Reply #7 on:** Jun 03, 2007, 10:00:43 AM »

also, looking for a fan shroud as well if you got it?

Glen1978 · « **Reply #8 on:** Jun 03, 2007, 10:46:25 AM »

Dont have any of that man. I think I do have a fan shroud though. I will be going to the shop here in a bit and will see what I got.

Quote from: billybobf on Jun 03, 2007, 09:56:50 AM

I NEED A COMPLETE A/C setup, a good compressor, that hasnt been sitting open, or used as on board air, lines, dryer, condenser, basically everything except the in dash box, but need the switch and junk

BoG-ToY · « **Reply #9 on:** Jun 03, 2007, 11:24:58 AM »

does anyone know if the fan shroud swaps from an 87 to an 89? they seem to run the same radiator as far as autozone says, if you got the shroud, I need it to be in GOOD shape, no cracks or anything, I threw away the old on cuz I didnt feel like putting epoxy on it

BoG-ToY · « **Reply #10 on:** Jun 03, 2007, 11:30:44 AM »

ok, its all good, I need an 89s a/c setup anyways....

skyscraper · « **Reply #11 on:** Jun 03, 2007, 12:28:06 PM »

Quote from: Glen1978 on Jun 03, 2007, 08:42:56 AM

Something in my head is telling me the column is not tilt. I will have to check it today and also on the A/C. What were you needing from the A/C?

ya i dont think so either, but check

Glen1978 · « **Reply #12 on:** Jun 03, 2007, 06:33:30 PM »

I checked/pulled the column tonight and it is in fact a tilt column! It has the key and all works good. I would like to get around $75-100 for it plus shipping. I will even throw in the steering wheel and trim around the column for the $100 bucks.

This truck has no A/C, sorry.

Fan shroud is in good condition. $25 plus shipping

skyscraper · « **Reply #13 on:** Jun 03, 2007, 07:40:04 PM »

can i get a pic or two of the column? thanks

Glen1978 · « **Reply #14 on:** Jun 03, 2007, 08:10:44 PM »

You bet man, but it will be tomorrow evening before I can do it. I will try to post them up here but send me your email address if that dont work.

BoG-ToY · « **Reply #15 on:** Jun 03, 2007, 08:25:20 PM »

can you figure out what shipping should be to 32542, if its too much Im probably just gonna look into an electric

Glen1978 · « **Reply #16 on:** Jun 03, 2007, 08:28:21 PM »

Heck it shouldnt be too much, it dont way nothing. Just the size of the box. I will try to locate a box and get a quote.

Glen1978 · « **Reply #17 on:** Jun 04, 2007, 05:28:21 PM »

Glen1978 · « **Reply #18 on:** Jun 04, 2007, 05:30:43 PM »

Here are the pics of the cloumn and the fan shroud for you guys. Thanks.

If you get me an address for the fan shroud I can check shipping tomorrow.

Let me know on the column and I will get it in a box and check on the shipping.

rfj60 · « **Reply #19 on:** Jun 04, 2007, 05:49:26 PM »

gotta 5sp tranny?

Glen1978 · « **Reply #20 on:** Jun 04, 2007, 05:55:50 PM »

Only drivetrain for sale is the IFS frontend (minus the hubs and calipers)

BoG-ToY · « **Reply #21 on:** Jun 04, 2007, 07:22:42 PM »

I dont know if the shroud will fit on my truck, I dont think its offset for some reason..... I will have to looki at it and get back to you tomarrow

Glen1978 · « **Reply #22 on:** Jun 04, 2007, 08:09:50 PM »

OK, lemme know what you come up with.

Glen1978 · « **Reply #23 on:** Jun 07, 2007, 01:38:59 PM »

toyotaexo · « **Reply #24 on:** Jun 07, 2007, 01:49:15 PM »

interested in power steering box shipped to 90660 ca thanks

skyscraper · « **Reply #25 on:** Jun 07, 2007, 02:17:35 PM »

I think I'll pass on that column. thanks anyway though.

Glen1978 · « **Reply #26 on:** Jun 07, 2007, 02:34:19 PM »

I am keeping the steering box. sorry

chim · « **Reply #27 on:** Jun 08, 2007, 01:47:04 PM »

Im interested in the column plastic shipped to 97070... $$ ??

Glen1978 · « **Reply #28 on:** Jun 08, 2007, 01:49:45 PM »

$25 shipped sound fair?

thirdgrader · « **Reply #29 on:** Jun 09, 2007, 06:08:57 PM »

Need the stock rear mudflaps if you have any.

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Glen1978 [OP]

Related Topics