0 Members and 4 Guests are viewing this topic.
Hello,For a project, I need an output shaft that will fit a driveshaft disconnect device https://trailtough.com/product/rear-drive-disconnect-for-toyotas/which I believe is a 21 splined output shaft from the following vehicles1979 – 1995 Toyota pick up1985 – 1995 Toyota 4Runner1995 – later Toyota Tacoma gear driven non-turbo cases onlyis that correct? Does anyone have a picture of one?
Thanks, do you have any ideas on obtaining one?
Ok thanks. Once I get enough posts I will post a Wanted to Buy in hopes that someone doing the mod you are referring to will have an extra one.I'm adding this to a non toyota vehicle, so I don't have anything to start from.
Yes that's correct. I need the front portion to adapt to a factory slip yoke, then the DSD and then off to the front differential. It's a Nissan.Trail tough told me the rear pinion spline is the same but it's very tight to slide onto and therefore could damage the bearing during install.
Thank you for these. Fortunately Marlin just called me and told me they had a used one to sell for 45 dollars, so I bought it and it'll be here sometime next week with my DSD.
Started by Aaronn Parts For Sale
Started by Willy Mammoth Parts Wanted
Started by Marketing New Announcements and Info
Started by Luthierman Project Research and Build-Ups
Started by 808newbie New Member Check-In!