Topic: Driveshaft mods for 5"SAS?

[bcjrunner]

 What kind of driveshaft work am I going to need when I do my 884runner 5" TG SAS? I dont have gears yet for the front and im not going to have 4wd for a little bit. I saw a kit. Is that for people doing it themselves? Are there any good cheap tricks for the front? I am going to find out what i need when I get to it but am looking for an Idea of what to expect. sorry for the newbie question but I am.

[Toymin8r]

your going to need a long travel spline front driveshaft.  You can buy a spline kit from marlin and have it welded to your stock tube or have a complete custom front shaft made.  The stock rear should be fine without mods.

[Monster Yota]

You could always make the front DL out of square tubing as well, its really easy and cheap!   
Otherwise buy marlins long slip or have high angle DL make a set for you!     

[79coyotefrg]

What kind of driveshaft work am I going to need when I do my 884runner 5" TG SAS? I dont have gears yet for the front and im not going to have 4wd for a little bit. I saw a kit. Is that for people doing it themselves? Are there any good cheap tricks for the front? I am going to find out what i need when I get to it but am looking for an Idea of what to expect. sorry for the newbie question but I am.

http://board.marlincrawler.com/index.php?topic=36377.0

[yotatough]

http://www.pirate4x4.com/forum/showthread.php?t=90517

[bcjrunner [OP]]

Alright, Ya I think im going square. Im just about out of cash for the build at the moment so it sounds good..