Topic: driveshaft?

[bigarms23]

I have a 19884runnersr5v6 5spd. Last summer i pt a 12bolt(it was free) in the rear and since then i have 2 different shops do a rear driveshaft the shops were southbay driveline and reno driveline&gear and i am still having driveshaft problems in the rear so what company should i try next

[BLACKDOG]

I had a shop in Sacramento do mine.  did a great job, shortened it, 2 piece to 1 piece, and used thicker tubing.  I'll see if I can remember the name.

[Rockcrawlintoy]

are you runnin a cv? do you have dual cases? you sure its set up correctly.

[bigarms23 [OP]]

yes it is a cv and yeah i have dual cases it setup correctly

[BLACKDOG]

I'm pretty sure this is the place.  I'm not at home so I can't check the receipt, but I think its right.

702 Houston Street
West Sacramento, CA. 95691
fax-916-371-6477
800-332-2800

[jrock]

Remember what it cost?

[BLACKDOG]

Remember what it cost?

About 200 I think, mabye a little less.  They basically just made a new driveshaft for me.  Replaced the u joints, and used the ends, and the slip joint, but used all new tubing (forgot what size, but a lot bigger dia. and thicker than the stocker)  I'm real happy with it.  They did a good job on it.

[jrock]

Thanks, I think Ill check them out.

[bigarms23 [OP]]

thanks for the help guys i will try that place in sac. or a shaft from je reel

[SLIVER]

My shaft is a Woody!
The one in my 4runner that is.

www.4xshaft.com

[bigarms23 [OP]]

I ll talk to tom wood and see between the 3 i have in mind to see what fits my budget