« on: Jan 30, 2004, 11:39:14 PM »
Randys kit includes a new custom spindle. I would like to beleive that Randys axle would slide right in. You are correct, Randys kit is a direct copy of Keiths design. Keith told me this in person
Keiths axles were made by Mosser.
I beleive that Randys axles are made in India?
The only sure way would be to remove your axles, and measure them, then call Randys and check to see if they really are the same.
Marlin
« Last Edit: Jan 30, 2004, 11:40:34 PM by Marlin »
Logged
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....
