« on: Dec 28, 2003, 11:25:32 PM »
I almost forgot-in 92 Toyota made major changes to the W56. Were the shift shaft bushings replaced? Toyota dose not service these, I make my own press then in and ream the bushings to fit.
Drstranger, I was hopeing you would of found a W56 by now-hate to see you put in that weaker G52
Marlin
Logged
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....