« on: Aug 26, 2005, 08:59:07 PM »
I have exchanged many of these trans rear housings.
It is easier if you stand the trans on the bellhousing and remove the two detent plugs. You will need a 12 mm, 14 mm, and 24mm or 15/16 sockets.
Logged
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....
