That's out.
That's also out, I spy some potential issues.
Its awaiting the needle gun.
I am also looking at some seriously long jack stands as the single post is quite limited in some aspects. I need to reposition the legs holding the rear of the truck so I can start to cut the radius arms brackets off. It would be handy if I could put it on stands and move the lift out of the way.
The next thing on the list is to get it on springs so I can wheel it to the two post and lift the body off ready to prep the rest of the frame and cut the unnecessary bracketry off the frame.
It would appear that a replacement fuel tank would be difficult to find so I may end up making one from Aluminium, which would be interesting as it would allow me to half the depth of it and raise the top as the thing has a body lift and will retain it. This will mean that the tank will be up higher in the frame and wont be draggin its balls in the dirt and over every damn lump and rock it comes to.
