Author Topic: Corroded hub found during rebuild- would you run it?  (Read 2262 times)

0 Members and 4 Guests are viewing this topic.

IVrunner

  • Offline Rock Master
  • ***
  • Turtle Points: 23
  • Male Posts: 352
  • Member since Oct '06
  • Santa Barbara, CA
    • View Profile
    • Buy me a beer
Thanks for the responses.  That’s what I figured.  What you are seeing is cleaned up the best I could.  You should have seen them when I started...

 I do have good IFS hubs and was looking at going that route but many of the builds I saw looked a little sketchy.  I’ll check out the front range kit.
~Josh
-87 4Runner SR5 - SAS, 4.88's, 33 KM2s, Lockright front, elocker rear, frenched hangers, TG in front, 63’s in rear (DD)
-2010 4runner Trail (wife DD)
-2000 4runner 4WD manual Highlander -SOLD:(
-1986 Toyota pickup SAS on 35s -SOLD
-1985 4runner (first car) -SOLD

 
 
 
 
 

Related Topics

17 Replies
2437 Views
Last post Jan 07, 2008, 04:43:42 PM
by lucky7
42 Replies
5701 Views
Last post Jan 16, 2009, 07:17:50 AM
by gmack192
7 Replies
1805 Views
Last post Nov 22, 2014, 08:49:09 AM
by Erick561
8 Replies
6246 Views
Last post Aug 08, 2017, 05:20:25 PM
by 58rennur4
3 Replies
1396 Views
Last post Jun 20, 2019, 08:38:09 PM
by mrspib