The inspection plate/dust cover is in 3 pieces
Upper: 1135565011 (plate, rear end)
Lower: 113610C010 (cover, flywheel housing under)
Seal in between upper and lower: 1135475010 (seal, flywheel housing, dust)
I was missing the lower cover and dust seal. Priced these out, shat a brick, then went back to the yard I got the engine from. Found the lower cover in the dirt in front of the donor, but no dust seal. RTV took care of it. Really the covers are just stamped flat tin pieces. Most any sheet metal cut to fit should take care of the lower cover. Upper is more complex.
So ordered these and they showed up. I looked at the diagram associated with it and ordered bolts as well. Well sure enough they are definitely not the right ones (about half the size of the ones I need). Do you happen to know the P/N for the bolts that go into the bell-housing for the inspection plate?