Author Topic: Driveshafts  (Read 1565 times)

0 Members and 1 Guest are viewing this topic.

skyscraper

  • Trade Count: (0)
  • Offline Crawler Guru
  • ****
  • Turtle Points: 0
  • Male Posts: 589
  • Member since Jan '07
    • View Profile
Driveshafts
« on: Jun 29, 2014, 04:21:26 PM »
Schedule 40 rear driveshaft with cv joint. 47" collapsed length. Also has additional tubing welded around the spline area.  Was used in an 84 long bed pickup with TG 5" lift kit and duals. This shaft only has two trips on it, some scrapes shown in the pics but NO dents. Not balanced.
$125 + shipping

Square front shaft from the same truck above.
SOLD

Located in Las Vegas

« Last Edit: Jul 03, 2014, 06:47:30 PM by skyscraper »

skyscraper [OP]

  • Trade Count: (0)
  • Offline Crawler Guru
  • ****
  • Turtle Points: 0
  • Male Posts: 589
  • Member since Jan '07
    • View Profile
Re: Driveshafts
« Reply #1 on: Jun 29, 2014, 04:52:12 PM »

81 toyota

  • Trade Count: (0)
  • Offline Rock Master
  • ***
  • Turtle Points: -2
  • Male Posts: 241
  • Member since Oct '11
  • 81 toyota detroit front spool rear 35x14.5 boggers
    • View Profile
Re: Driveshafts
« Reply #2 on: Jul 02, 2014, 06:13:54 PM »
Are the u joints in the rear drive shaft still good?

skyscraper [OP]

  • Trade Count: (0)
  • Offline Crawler Guru
  • ****
  • Turtle Points: 0
  • Male Posts: 589
  • Member since Jan '07
    • View Profile
Re: Driveshafts
« Reply #3 on: Jul 02, 2014, 08:20:49 PM »
The u joints seem fine. Like I said the shaft only has 2 trips on it, and I drove it in the dirt only but I didn't notice any problem with them. And checking them by hand they seem ok.

skyscraper [OP]

  • Trade Count: (0)
  • Offline Crawler Guru
  • ****
  • Turtle Points: 0
  • Male Posts: 589
  • Member since Jan '07
    • View Profile
Re: Driveshafts
« Reply #4 on: Jul 03, 2014, 06:47:49 PM »
Square shaft is sold!

skyscraper [OP]

  • Trade Count: (0)
  • Offline Crawler Guru
  • ****
  • Turtle Points: 0
  • Male Posts: 589
  • Member since Jan '07
    • View Profile
Re: Driveshafts
« Reply #5 on: Jul 14, 2014, 09:29:11 AM »
Bump

 
 
 
 
 

Related Topics

0 Replies
986 Views
Last post Aug 17, 2005, 08:16:28 PM
by rhundl
9 Replies
2403 Views
Last post Oct 10, 2005, 12:32:14 PM
by freds40
7 Replies
2214 Views
Last post May 10, 2006, 12:25:23 AM
by toyotamobing
14 Replies
2570 Views
Last post Jul 01, 2006, 08:49:14 PM
by 98Taco
driveshafts
7 Replies
1981 Views
Last post Oct 10, 2007, 05:18:09 PM
by Duffil