Topic: 75-95 Toyota Pickup Truck 4Runner Part Liquidation Venue OEM ETC I ship from CT

[Erick561]

Busy As Fu¢k over here remodeling my new hq juggling 4 labor jobs eBay and renovation just got a new septic system in the wetlands holding it down haven't had much time to do listings sorry about the distance o blood going strong eating organic drinking wellwater soaking up those sun rays pumping that work product out

[Vandy]

Do you have an IFS steering box? Need one for my 86

[Erick561 [OP]]

Just sold one locally for $125 will let you know when I drive the next one in

[mookie7971]

Looking for a ‘89 or newer upper intake for a 22re complete with throttle body and all sensors, Cold start idle air bypass etc., shipped to 30179 GA

Thanks!

[Erick561 [OP]]

Ok haven't had time to dismantle the 93 2wd one I have rn I'll pop it up on eBay if all comes off as expected but my schedules booked til beginning of June already so been having trouble getting out of work before the noise ordinance shop echos

Looking for a ‘89 or newer upper intake for a 22re complete with throttle body and all sensors, Cold start idle air bypass etc., shipped to 30179 GA

Thanks!

[slcfd2289]

Looking for power steering components for a 22RE, including the ps box. I've got an 83 with manual steering the previous owner put a new 22re into. looking for bracket, pump, pulley, etc. You have anything along those lines?

[Carolina82]

Do you have any red interior pieces from a 1st gen 4runner?

[helipilot77]

I am also looking for Maroon/Burgundy/Red 1st gen 4runner trim. Specifically the shifter trim that the shifter boot clips into.

[calux]

also interested in interior parts (brown/tan, seats would be awesome)

do you have anything for right-hand-drive 1st gen Runners/4th gen pickups?

thanks

[1rishpride]

Do you have back seats for a 1st gen 4runner?  Thanks

[bigwill837]

Do you have an RF1A top-shift transfer case?

[idahank]

Do you have a first gen 4x4 pickup grill?

[dzldust]

1987 4runner parts needed,
Need some red interior parts,shifter surround,interior door handle trim,rear cargo panels

[Mike Holme]

Hello I am looking for Gray 84-88 Xtracab pickup seatbelt receivers, meaning the female plastic covered part that bolts to the floor between the console and bucket seats. Also looking for heater controls(no cables needed) and factory clock for 88 Xtracab.
Thanks!

[Erick561 [OP]]

have been very busy sorry for late responses, been working 60+ hours a week locally

1987 4runner parts needed,
Need some red interior parts,shifter surround,interior door handle trim,rear cargo panels

will check on door handle trim i think i still have red from an 86 but the shifter surround was brittle and broken, sold most of the red interior might have a cargo panel I think they were sun damaged and brittle

Hello I am looking for Gray 84-88 Xtracab pickup seatbelt receivers, meaning the female plastic covered part that bolts to the floor between the console and bucket seats. Also looking for heater controls(no cables needed) and factory clock for 88 Xtracab.
Thanks!

I have several 2nd gen gray seatbelts pretty sure female receiver same for single cab bucket, have to check on them I think a set was decent but one the eyelet that bolts to floor was rusty.  might only have a 3rd gen heater control on hand right now.  last factory clock I pulled has a scratched lense

any chance you have an early lower steering shaft lying around? looking for the earlier version without the rubber "giubo" piece. thanks in advance

Mike

do you need 16"?  yes
pm sent

[4lowandslow]

Do you have a gray 4wd shifter bezel? for a 84-89

[Mike Holme]

I have several 2nd gen gray seatbelts pretty sure female receiver same for single cab bucket, have to check on them I think a set was decent but one the eyelet that bolts to floor was rusty.  might only have a 3rd gen heater control on hand right now.  last factory clock I pulled has a scratched lense


[/quote]

The rust is not a concern. I am in need of the plastic support sleeves more than anything. How much for drivers and pass side gray seatbelt receivers sent to 84532?
Thanks and Happy New Year!

[Erick561 [OP]]

in the middle of building another 20r/22r hybrid, sorry for late replies

[Mike Holme]

I have several 2nd gen gray seatbelts pretty sure female receiver same for single cab bucket, have to check on them I think a set was decent but one the eyelet that bolts to floor was rusty. 




The rust is not a concern. I am in need of the plastic support sleeves more than anything. How much for drivers and pass side gray seatbelt receivers sent to 84532?
Thanks and Happy New Year!