Just Rolled.. help

[konarider1993]

I rolled the 4runner in my buddys back yard. What do i have to do to start her in the morning? Change the plugs and what else? I just got a new head and motors good so i dont wanna  mess. any help 

[bleakhorizon]

i would say... check oil, pull plugs crank over, install plugs, go.....  of course check other fluids as well but engine oil and hydro locking are the two i could think of for the motor alone

[konarider1993]

i would say... check oil, pull plugs crank over, install plugs, go.....  of course check other fluids as well but engine oil and hydro locking are the two i could think of for the motor alone

sounds good thanks for quick reply

[konarider1993]

sounds good thanks for quick reply

It Still runs like poo, when i pulled the plugs and cranked it over oil shot probably 15 feet and after that i stuck new plugs in, but still losing power.

[junya92toy]

Could of done some internal damage when you hydrolocked it

[86bobbedtoy]

how long did you run it after?
you might need to burn out all the oil
good luck

[junya92toy]

And you might have to change the plugs a few times

[konarider1993]

how long did you run it after?
you might need to burn out all the oil
good luck

I have ran thru about a half tank rippin on it everywhere, hoping i just have to burn out oil still.

[konarider1993]

And you might have to change the plugs a few times

yeah the stock ones are ngk v power that i should use right?

[junya92toy]

Yes I use ngk in mine.

[IMMUDDY]

Check the rubber boot that connects your intake. I ripped mine and it would not run til I duct taped it and finally replaced it.

[konarider1993]

Just got it running good yesterday, plug wire #4 was screwed up