I've got an 84 sc/sb that I put a 1st gen 4runner body on, the fuel tank that was under my flatbed will no longer work
with this set-up ( It hangs down too low)
Here's a link to it :
http://board.marlincrawler.com/index.php?topic=50836.msg726042#msg726042I've got a friend that works in a fab shop that offered to make a fuel tank at cost for me. So I'm thinking around 25gal. (30x30x7)
between the rear frame rails. My big concern is the position of the filler neck in relation to the tank, its going to have a sweep in it but the fuel cap is still higher than the tank inlet, (see green line in pic)
with the vent on the tank i'm thinking it'll be ok, but i don't want a truck that's a pain in the rear to fill.... I don't want to cut into my rear seat space, but i suppose i could cut into the inner body panel and partially run the filler neck through the wheel well to the tank.
What do you think?