« on: Dec 01, 2004, 09:19:06 PM »
im going to get a new welder for xmas and the two i am looking at are the millermatic 210 and the lincoln 215. i dont know a hole lot about welders so what do you guys think? im sure they are a little big for home shop use but what the heck. they are both the same price.
![](https://board.marlincrawler.com/Themes/MCI_V3C/images/ip.gif)
Logged
89 ext cab sas with diamond +4 1/2" housing 30 spline longs and hub gears, hp elocker, six studs, arp studs in everything, taco rear with elocker. swaped out 22re for 3.4l supercharged, urd 2.0" pulley, urd fuel management, downey headers, flowmaster, cold air intake, marlin clutch that is straining to hold up