Topic: WHAT 4X CLUBS ARE IN CENTRAL VALLEY

[TPI-ZZ4-FJ40]

HEY OUT THERE
WHAT CLUBS ARE IN THE CENTRAL VALLEY LOOKING FOR SOMEONE TO GO WHEELING WITH
E-MAIL ME
MIKE DIQUIRICO
mikediquirico@yahoo.com
See YA

[CruzrDave]

I've been toying with starting a new club. I have had a lot of intrest. Ever sence Toys-4- Fun died there hasn't been any Toys only club worth a . I know I can round up 2 hand fulls of Cruiser owners(10), plus I've meet a bunch of guys out in your area. Your more then welcome to come with us , we have a lot of planned runs plus lots of unplanned runs. July 11th we're leaveing for Rubicon, be back on Sunday. Also have plans for Dusy/Ersim but don't know when it will open.
DAVE

[CruzrDave]

TPI

Hey Mike, whats the deal on that TPI unit you got. What year, model? Is that the 86 corvette one you had? Is that the MAP or MAS sensor? Also you want to pick up a few tranny jobs? It be putting in the 3.06 in my TH350. I lost your # can you send it to my email or PM. Hey I'll trade you my 4-runner for your Cruiser

[RogueDogg]

Can't wait till I can take my truck to the Rubicon...Soon enough, hopefully I can meet up with ya'll on some trails some day....


Brian "ROGUEDOGG" Ford  

[TPI-ZZ4-FJ40 [OP]]

HEY Dave ,
I have misc pieces to make a complete tuned port setup I have early strait ,and angled bolt manifolds gave up making my own time looms it cost to much in time and connectors,Its cheaper all around to buy one built 175 to 250,I would run map setup ,its cheaper in parts,less parts(relays,maf,wires,etc),but it harder to tune in than MAF,MAF is a lot more forgiving (cam compression,etc) Also have Throttle body setup Just finished up one on a el camino,It came out of a cop car , I can pick up complete cop cars (drive home) 1,000 , LT1 or TBI Setups with 4l60E Trans Killer deal Take the car Play crash derby when done pull the killer drivetrain
          THANKS
           MIKE

[CruzrDave]

LT1 This is what I'd like to run. How much for just a motor?

I'll need the angled bolt manifold. Isn't MAF the one that allows the use of a K&N right at the plenum? Or is that MAP. Thats the one I want. But I'd take what I can get :'(. Give me a price on that and which one you have. The Map sounds like it would be less to mess with(i hate relays and wire/ 22re conversion in my 4-runner has traumatized me :unhappy:  ) I'll buy a harness from Howel or some one thats not problem. I sold my TBI350 to a friend when I was in need of some money, it is every so bad ass in his cruiser . Do you know were I can get good but cheap parts for my 350( oil pump, timing chain, gasket)?
Call me
DAVE

[HighToy]

Here you go...about 25 that are registered with Cal4wheel. I'm sure there are more.

http://www.cal4wheel.com/clubs/central.html