Topic: wich tranny to run?

[Steve_925]

so im starting a new project soon and im starting to get parts together. im using all the stuff off my 4runner wich has a 3.o and im gonna be using a 22re. so im not sure if i should keep my 23 spline with the adapter and buy a turbo tranny. or buy a 4 cyl tranny and change the front case to 21 spline. ?? oh and i was wondering will a turbo bell housing bolt up to my 3.0 trans. cuz that would be perfect

[THK Matt]

just buy a turbo tranny man. and all you have to do is bolt it all up, minus the front adapter

[joey0712]

23 spline is the way to go for sure!!!

[79coyotefrg]

so im starting a new project soon and im starting to get parts together. im using all the stuff off my 4runner wich has a 3.o and im gonna be using a 22re. so im not sure if i should keep my 23 spline with the adapter and buy a turbo tranny. or buy a 4 cyl tranny and change the front case to 21 spline. ?? oh and i was wondering will a turbo bell housing bolt up to my 3.0 trans. cuz that would be perfect

if you already have the 3.0 tranny to gear drive adapter,  keep the v6 tranny  and get a turbo bell housing, and bolt the 22re  right up

[THK Matt]

if you already have the 3.0 tranny to gear drive adapter,  keep the v6 tranny  and get a turbo bell housing, and bolt the 22re  right up

actually there is the best way to go
as the R150F has a slightly lower transfer low gear, and a think a slightly lower first gear in the tranny then the 22RE trans.

[Steve_925 [OP]]

if i can run the turbo bell housing on my v6 tranny thats what ill do

[THK Matt]

if i can run the turbo bell housing on my v6 tranny thats what ill do

you can, its what 8 or 9 bolts to unbolt your 3VZ-E bellhousing and then bolt the 22RTE Bellhouding on.
some one on this board has R151F tranny parts. search it

[unclejpl4x4]

I think you should go with a tranny that works

[Steve_925 [OP]]

just bought a bell housing from some guy on pirate. thanx for the help

[THK Matt]

just bought a bell housing from some guy on pirate. thanx for the help

the Turbo housing? to mate your R150F Setup?

[Steve_925 [OP]]

yup. hopfully it works out

[THK Matt]

yup. hopfully it works out

should its a simple bolt on application.

[jimbo74]

sounds lie kthe way to go..... look into changing the clutch while you are in there too, at least look @ it... no sense in swapping out the bellhousing only to have your clutch fail next month.....

[KDXSR5]

and check out the pilot and release, never hurts to change them

[ROCKO]

so i guess i have to stop by to see what your building now