Topic: Where do these two brackets go?

[JohnHalladay]

I came out with more parts than i stated with. theats never a good thing! hahaha 

[*ROKTOY*]

Do believe they are for the PS pump, I'm for sure the top one is.

[Rockcrawlintoy]

top ones power steering. i didnt put in back on when i did my timing chain i was way lazy.

[JohnHalladay [OP]]

is it a problem if there not on?

[*ROKTOY*]

Toyota put them there for a reason.

[Slolyfe]

Ive run my 22r for a year without that bracket ps that is.  Never seen the other one

[SolidAxle]

little one is a newer efi fuel filter braket. how does that ps braket work, i had no idea what it was for, don't you need the one from the idler pully and thats it ?
 

[WHITE_TRASH]

The big bracket is for the power steering pump.  It bolts to the bottom of the pump with the open end of the Y upwards and the lower end uses a single bolt on the timing cover.  The alternator adjuster bracket goes through the open Y and on to the alternator.

The smaller bracket is indeed for the fuel filter.  It bolts to the passenger side of the block up by the head and bellhousing.  It only fits one way so it shouldnt be too hard to figure out.

[JohnHalladay [OP]]

ok thanks i couldnt figure out what that big bracket was for. but now i know! thanks

[SolidAxle]

Also that fuel filter bracket will only fit flat top piston blocks aka ufo block aka '85 and up efi engines, the deck height is higher on older blocks and you have to cut off the tab that bolts to the intake to make it fit. I had to do it

[JohnHalladay [OP]]

well thats fine i have an 88 efi